Faber 5980410, 5980411 User Manual

Cristal HC

powerful, practical, pretty

slideout rangehood

°

slim styling

°

microswitch turns motor/lights on

°

when pulled out

closes flush with cabinets

°

easily replaces existing hoods

°

500 cfm

°

1 glass covered fluorescent light

°

3 speed control

°

dishwasher safe grease filters

°

convertible to recirculating

°

top or direct rear venting

°

Integrated Collection

built-in mounting system

°

sone range: 3.5 - 6.5

°

6” round duct

°

Size/Color/Model #

30 *

36 *

* white, black and brushed aluminum
front trims come with every Cristal HC
in the box

a

Charcoal Filters

c

For recirculating installations, high

c

quality, heavy duty filters ensure
the removal of smoke and odors

e

from the kitchen. Some ductwork is

s

required to exhaust the unit out of

s

the cabinet.

5980410

5980411

6093034

o
r
i
e
s

For a streamlined look in the kitchen, the Cristal HC is your
integrated solution. The Cristal HC has a sleek pull-out visor
which slides in, flush with your cabinets, neatly tucking the
hood away. For total integration, the front strip can be
replaced with material to match your cabinets, hiding the
hood completely.

Choose from a white, black, or
brushed aluminum front strip (all
are included in the box). For a
totally integrated look, the front
strip can also be replaced with a
custom built strip to match your
cabinets. See reverse for front
strip dimensions.

p.o. box 435 • Wayland, MA 01778 • tel: [phone] • fax: [phone] • e-mail: [e-mail] • www.faberonline.com

Dimensional Diagrams

Cut-Out

Front View

Custom Front Panel Dimensions

Note: The Cristal HC comes standard in the top vent
position. The direct rear vent position can be achieved
by rotating the blower

housing.

Side View

Bottom View

1 15/32”

29 7/8” or 35 7/8”

3/4”

Pre-Planning Your Installation - Important: Consult the installation instructions before you begin installing

this rangehood. The recommended height to install this hood off the cooktop is a minimum of 24” and a maximum of 30”

for maximum effectiveness. Also consult the cooktop manufacturer’s recommendation.

Pre-Planning Your Ductwork - Important: Consult the installation instructions before you begin installing this rangehood.

Make your ductrun as straight and

short as possible. The ductrun
should not exceed 35 equivalent feet
if ducted with the required minimum
of 6” round duct. Count 45º angles
as 3 feet, 90º elbows as 5 feet, and
90º flat elbows as 12 feet.

For best results, use no more
than three 90° elbows. Make sure
that there is a minimum of 24”
of straight duct between elbows
if more than one is used. Do not
install two elbows together. If you
must elbow right away, do it as
far away from the hood’s exhaust
opening as possible.

For more efficient airflow when
venting to the rear: Rotate the
Cristal HC blower housing so that
the 6” round exhaust outlet faces the
back, rather than running ductwork
up and elbowing back.

WARNING! Product specifications are subject to change without notification. Consult the installation instructions
before you begin installing this rangehood.

Recirculating Installations

For installations where ductwork to the outside of your home is impossible or highly impractical
Charcoal Filters, which attach to the blower assembly, absorb smoke and odors.

cabinet

6” round

duct

hood

ceiling

vent grate

soft

vent grate

cabinet

6” round

duct

hood

ceiling

Some ductwork must
be installed to exhaust
the rangehood back
into the kitchen, either
at th e t o p o f t he
cabinet or at the face

of the soft. A plastic

vent grate supplied
with the rangehood
can be used to cover
the duct opening. This
duct work must not
terminate into a dead
air space.

Rev.06/08