Extron electronic MPA 152 PLUS User Manual 2

MPA 152 Plus • Setup Guide
LR
Slee
Slee
Tip (+)
The Extron MPA 152 Plus is an ENERGY STAR® qualied mini power amplier. It delivers up to 15watts (rms) per channel stereo or dual mono into a 4ohm sound system, or 8 watts (rms) per channel into an 8ohm system.

Installation

To install and set up an MPA 152 Plus, follow these steps:
1. Turn off all equipment and disconnect from power
sources.
2. Mount the Extron MPA 152 Plus on a rack, under a
desk, or on a projector pole.
ATTENTION: Although the amplier is plenum
rated, the power supply provided with it is not. The power supply must not be placed in the plenum space. Cables to and from the amplier must be plenum rated.
NOTE: Use only the two round mounting holes for mounting the MPA 152 Plus. The other four (hexagonal) holes anchor
stand‑offs for the internal circuit boards. Using them may damage the amplier and does not provide secure mounting for the unit.
INPUTS
MPA 152 PLUS
R
POWER 12V
0.7A MAX
L
Extron MPA 152 Plus
Mini Power Amplier
1
VIDEO
2
DISPLAY
AUX
OFF
VIDEO
3
ON
PC
4
VOLUME
IMAGE
CONFIG
MUTE
Projector
RS-232 or IR Projector control
Audio
OUTPUT REMOTE
Ω
R
4 / Ω 8
L
CLASS 2 WIRING
50mA
VC G
10V
R
L
Audio
Audio
Extron SM 3
Full-range Speakers
Audio
S-Video
RGBHV
Video
DVD/VCR Combo
MLC 104 IP PLUS
Extron
Extron MLC 104 IP Plus
MediaLink Controller with IP Link
Laptop
3. Attach the speakers to the MPA 152 Plus output, using the 4‑pole,
5mmcaptive screw receptacle (see the gure at right).
ATTENTION: Do not ground or short the speaker outputs as this will
damage the amplier.
4. Attach inputs to the MPA 152 Plus unit from the audio source, the
INPUTS
projector, or both. There are three audio inputs (shown in the gure at right), which can be used individually or together.
L
1 32
a One pair of RCA receptacles — these receptacles accept unbalanced, line level audio signals.
The input can be stereo, using two RCA connectors, or mono, using a single RCAconnector plugged into the left receptacle. If unused, the receptacles automatically terminate to lower the noise oor.
b One 3.5 mm stereo tip-ring-sleeve receptacle — this input also accepts unbalanced, line
level audio signals through a 3.5 mm tip ring sleeve (TRS) stereo connector. If unused, the receptacle automatically terminates to lower the noise oor.
c One 3.5 mm, 5-pole captive screw receptacle — this 5‑pole 3.5 mm captive screw receptacle
accepts line level, balanced or unbalanced, mono or stereo audio signals.
R
/
4
Ω
8
Ω
CLASS 2
WIRING
L
Sleeve ( )
RCA Connector
Tip (L)
Ring (R)
Sleeve ( )
3.5 mm TRS Connector
OUTPUT
R
R
L
Tip
Tip
ve
ve
LR
Unbalanced Stereo Input
Tip
Ring
Sleeves
Tip
Ring
Balanced Stereo Input
LR
Sleeve
Tip
Unbalanced Mono Input
LR
Sleeve
Tip
Ring
Balanced Mono Input
1
MPA 152 Plus • Setup Guide (Cont’d)
w
BASSLEVEL TREBLE
MINI POWER AMPLIFIER
STEREO
The MPA 152 Plus sums and weights the left unbalanced signals from the TRS and RCA receptacles. This summed, unbalanced signal is then summed with the left balanced signal from the captive screw receptacle. The right channel is handled in the same way.
The left and right channels are then sent to the output ampliers in one of two ways, depending on how the front panel switch is set (see the diagram to the right).
z Stereo: The left and right channels are sent to the left and right output amplifers respectively.
z Dual Mono: The left and right channels are summed and then the resulting mono signal is fed to both of
the output ampliers.
NOTE: The captive screw, RCA and TRS inputs are buffered.
DUAL MONO
5. Connect the pre‑wired captive screw connector to one of the 2‑pole,
3.5 mm captive screw outlets on the provided power supply and the other end into the power receptacle on the amplier (see the gure to the right). The power cord connectors are correctly wired when shipped. The MPA152 Plus ships with a 24 W desktop power supply.
ATTENTION:
MPA 152 Plus
Amplifier
POWER 12V
0.7A MAX
Power Receptacle
• See the attention notices in the Power Input section of the
MPA152 Plus Series User Guide for important information about using power supplies.
DC Power Cord Captive Screw Connector
• When the power supply is connected to the MPA152Plus, it
must not be shared with any other devices.
6. Adjust the MPA 152 Plus input level, bass, and treble from the front panel (see gure at right).
a. If necessary, unplug the remote connector from the unit (see step 7, below).
b. If connecting the amplier to a system with adjustable volume, set the system volume
to its lowest point. Then adjust the MPA152 Plus front panel level potentiometer fully counterclockwise.
c. Set the system volume to its maximum volume level (no sound should come out).
d. Return to the MPA 152 Plus and raise the level until sound distortion rst occurs, then lower slightly until the distortion
disappears. This setting ensures that, whatever the system volume setting may be, no clipping occurs.
e. Adjust bass and treble to preference.
7. The rear panel 3‑pole Remote captive screw port on the amplier can be used for remote control of the
volume by an Extron volume controller such as an Extron VCM100 AAP, VC 50, or MLA VC10 Plus. A MediaLink controller can also adjust the audio volume via a network connection or by IR remote (see the MPA 152 Plus Series User Guide).
Power Supply
Output Cord
PS 1220
Power Supply
AC Power Cord
DO NOT USE
DC Power Outputs
Captive Scre Connector
Tie
Wrap
MPA 152 PLUS
VCG
10V50mA
REMOTE
Extron Headquarters
+1.800.633.9876 (Inside USA/Canada Only)
Extron USA - West Extron USA - East
+1.714.491.1500 +1.919.850.1000 +1.714.491.1517 FAX +1.919.850.1001 FAX
Extron Europe
+800.3987.6673 (Inside Europe Only)
+31.33.453.4040 +31.33.453.4050 FAX
© 2013 Extron Electronics All rights reserved. www.extron.com
Extron Asia
+65.6383.4400 +65.6383.4664 FAX
Extron Japan
+81.3.3511.7655 +81.3.3511.7656 FAX
Extron China
+86.21.3760.1568 +86.21.3760.1566 FAX
Extron Middle East
+971.4.299.1800 +971.4.299.1880 FAX
Extron Korea
+82.2.3444.1571 +82.2.3444.1575 FAX
Extron India
1800.3070.3777 (Inside India Only)
+91.80.3055.3777 +91.80.3055.3737 FAX
68‑1320‑52 Rev A 06 13
2
Loading...