Extron SMB 111, SMB 112, SMB 113, SMB 114, SMB 115 Setup Guide
...
IMPO RTANT:
IMPO RTANT:
Clamp
Fasten the clamp
to the SMB using
the two provided
#6-32 mounting
2
Route cables out
the rear of the SMB
and secure them to
the clamp using a
zip tie.
3
Clamp
Cable Shield & Rivet
Go to www.extron.com for the
SMB Table Clamp Kit • Setup Guide
complete user guide, installation
instructions, and specifications.
The SMB Table Clamp Kit secures Extron SMB boxes to table edges. The kit includes the
following items:
#6-32
Screws
Cable Wrap
Footpads
(SMB 210 Series only)
SMB Table Clamp Compatibility
The chart below lists the number of recommended clamp kits for each SMB model.
Table Clamp range is 0.38” to 2.00” (10 mm to 51 mm).
SMB 110 Series
SMB Model Clamp Quantity
SMB 111 1
SMB 112 1
SMB 113 1
SMB 114 2
SMB 115 2
Installation
Follow these steps to install the clamp kit.
SMB 210 Series
SMB Model Clamp Quantity
SMB 211 1
SMB 212 1
SMB 213 1
SMB 214 1 or 2
NOTE: Footpads are required if only
one clamp is used for SMBs that are
2-gang and larger.
1
If needed, apply the additional
anti-pivot footpads to the left
and right sides of the SMB
bottom panel.
SMB 213
2
Fasten the clamp
to the SMB using
the two provided
#6-32 mounting
screws.
Clamp
SMB Table Clamp Kit • Setup Guide (Continued)
Clamp
Fasten the clamp
to the SMB using
the two provided
#6-32 mounting
screws.
SMB 213
If needed, apply the additional
anti-pivot footpads to the left
and right sides of the SMB
bottom panel.
1
2
Tighten the clamp
to the table edge.
Clamp
Screw
Table
6
Clamp
Route cables out
the rear of the SMB
and secure them to
the clamp using a
zip tie.
3
NOTE: The cable shield below is compatible
only with SMB 210 Series boxes, except
for the SMB 211 which can not t the cable
shield.
3
Plastic
Rivet
Route cables out
the rear of the SMB
and secure them to
the clamp using a
zip tie.
4
Insert the tab
of the cable
shield into the
groove behind
the SMB.
Cable
Shield
5
Secure the cable
shield to the
clamp using the
included rivet.
Table
Clamp
Screw
6
Tighten the clamp
to the table edge.
For information on safety guidelines, regulatory compliances, EMI/EMF compatibility, accessibility, and related
topics, see the Extron Safety and Regulatory Compliance Guide on the Extron website.
© 2017-2021 Extron — All rights reserved. www.extron.com
Worldwide Headquarters: Extron USA West, 1025 E. Ball Road, Anaheim, CA 92805, 800.633.9876
All trademarks mentioned are the property of their respective owners.
68-2877-01
Rev. E
02 21
Loading...