
small Phillips screwdriver to remove the battery
2. Insert 1 - 9V battery, making sure to properly match the
efore using the 9.6 volt battery pack you must charge it. Follow the instructions on the battery
charger for properly charging the battery.
position before you begin installing the battery.
2. Turn the latches on the hood of the AmphibiCar to unlock it then remove the hood.
THEM TOGETHER. The connectors only fi t one way and should snap together easily.
4. Carefully tuck the battery wire into the battery compartment and replace the hood, turning the
latches to lock it into place.
Push both LEFT and RIGHT stick down.
stick up. Press LEFT stick down
stick up. Press RIGHT stick
Press the LEFT shoulder button to transform
from a car to a boat (see Figure 2).
Press the RIGHT shoulder button to trans-
form from a boat into a car (see Figure 3).
The remote control has a limited range. Should the vehicle exceed this range it will stop. Hold
the control higher or move close to the unit to re-establish a signal.
Install the antenna into the top of the controller,
• Please read the Userʼs Guide carefully before operating this product.
Children should not operate this product without parental supervision.
This product is designed for pool use. It may be used in ponds or small lakes provided that
there are no strong currents, waves, or water craft present which could create wakes. Do
not use in any other body of water or in salt water.
Keep hands, hair, and loose objects such as clothing away from the wheels.
If an object becomes lodged in the wheels, make sure that this product is turned off before
Always inspect the pool area before use to insure it is free of hazards and/or obstacles,
such as pool toys and etc.
Never ride into or over swimmers.
Always use caution and common sense.
• Do not submerge the unit.
2. Turn on the remote control (front center of unit).

EXCALIBUR ELECTRONICS, INC., warrants to the original consumer that its products are free from any electrical or mechanical defects for a period
of 90 DAYS from the date of purchase. If any such defect is discovered within the warranty period, EXCALIBUR ELECTRONICS, INC., will repair or
replace the unit free of charge upon receipt of the unit, shipped postage prepaid and insured to the factory address below.
The warranty covers normal consumer use and does not cover damage that occurs in shipment or failure that results from alterations, accident, misuse,
or attempted outside of the factory.
Any applicable implied warranties, including warranties of merchantability and fi tness, are hereby limited to 90 DAYS from the date of purchase. Con-
limitations on the duration of LIMITED 90-DAY WARRANTY implied warranties and do not allow exclusion of incidental or consequential damages, so
the above limitations and exclusions in these instances may not apply. The only authorized service center in the United States is:
Excalibur Electronics, Inc.
Miami, Florida 33186 U.S.A.
www.ExcaliburElectronics.com
including your daytime telephone number, inside the shipping carton. If your warranty has expired and you want an estimated fee for service, write to the
your unit. We cannot store your unit!
Excalibur Electronics, Inc. reserves the right to make technical changes without notice in the interest of progress.
• Do not submerge remote control in water or other liquids.
• Do not disassemble the product for any reason.
• Do not expose to extreme temperatures.
• Do not drop, throw, smash or otherwise cause physical shock.
• Clean using only a slightly damp cloth.
• Do not use cleaners with chemical agents.
• Do not short-circuit the battery terminals.
• Do not use rechargeable batteries.
• Do not mix old and new batteries.
• Remove exhausted batteries.
• Batteries should be installed and replaced by an adult only.
• Remove batteries when not in use.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-
This device complies with Part 15 of the FCC Rules Operation is subject to the following two conditions: (1) this device may not cause harmful interfer-
ence, and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the fol-
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.