Page 1
Motorized Bumper Boat
Model No.: PR11BK
Page 2
ongratulations on your purchase of the
Motorized Bumper Boat from Excalibur
Electronics. Sit on your very own infl atable
throne as you cruise the water thanks to the
powerful, single propeller.
Please read this manual thoroughly, especially
noting safety and care instructions. Keep this
manual for reference. This package contains 1
bumper boat, 1 electric pump and all its parts for
assembly and 1 userʼs manual.
MAIN PARTS LIST
Air Pump Control
Arm
Sleeve
Control Electrical
Arm Connection
Shaft
Steering Wheel Battery
and Compartment
Battery Cover
Lug Nut Propeller
INFLATING
YOUR BUMPER BOAT
2. Connect the nozzle to the air pump. Check to make
sure that this nozzle also fi ts into the Bumper Boatʼs
valve.
3.
There are two “cavities” where the Bumper Boat
needs to be infl ated. Turn on the air pump and
infl ate each cavity until it is fi rm.
4.
After filling each cavity, remember to close the valve
covers.
ASSEMBLING YOUR MOTORIZED BUMPER BOAT
Once you have properly infl ated the Bumper Boat, you
can begin assembling the motor and steering wheel.
cover.
2. Assemble the battery cover with the nuts, bolts and
o-rings in place.
3. Place the nut onto the bolt and then onto the battery
compartment.
4. Place an o-ring on the end of each bolt to fi nish
assembling the battery cover.
5. Match the direction of the “2” printed on the control
arm and the battery compartment. Slide the control
arm in through the bottom of the battery compartment.
Page 3
6. Screw the large plastic hexagon nut onto the top of the
battery compartment to secure the control arm
in place.
7. Insert 6 D-cell batteries into the battery compartment,
making sure to match the polarity (+ and -) with the
diagram inside the battery compartment.
by matching the “3” that is printed on both the cover
and compartment.
9. Fasten the nuts with the wrench. It is generally best
to start at the two nuts directly across from the handle,
then the two nuts on both sides of the handle, then the
last remaining two.
subassembly that encloses the propeller.
easier for the fi nal steps of the assembly.
the front-center of the Bumper Boat.
arm sleeve. Insert the electrical connection shaft
through the bottom of the control arm sleeve.
the “1” printed on both sides of the control arm and
propeller.
that it is tightly secured into the propeller.
5
Page 4
90-DAY LIMITED WARRANTY
EXCALIBUR ELECTRONICS, INC., warrants to the original consumer that its products are free from any electrical or
mechanical defects for a period of 90 DAYS from the date of purchase. If any such defect is discovered within the warranty
period, EXCALIBUR ELECTRONICS, INC., will repair or replace the unit free of charge upon receipt of the unit, shipped
postage prepaid and insured to the factory address below.
The warranty covers normal consumer use and does not cover damage that occurs in shipment or failure that results
from alterations, accident, misuse, abuse, neglect, wear and tear, inadequate maintenance, commercial use, or unreasonable
use of the unit. This warranty does not cover cost of repairs made or attempted outside of the factory.
Any applicable implied warranties, including warranties of merchantability and fi tness, are hereby limited to 90
DAYS from the date of purchase. Consequential or incidental damages resulting from a breach of any applicable express
or implied warranties are hereby excluded. Some states do not allow limitations on the duration of LIMITED 90-DAY
WARRANTY implied warranties and do not allow exclusion of incidental or consequential damages, so the above
limitations and exclusions in these instances may not apply. The only authorized service center in the United States is:
Excalibur Electronics, Inc.
Miami, Florida 33186 U.S.A.
Phone: 305.477.8080
Fax: 305.477.9516
www.ExcaliburElectronics.com
Ship the unit carefully packed, preferably in the original carton, and send it prepaid, and adequately insured. Include a
letter, detailing the complaint and including your daytime telephone number, inside the shipping carton. If your warranty
has expired and you want an estimated fee for service, write to the above address, specifying the model and the problem.
NOTE:
Please do not send your unit without fi rst receiving an estimate for servicing from EXCALIBUR ELECTRONICS,
INC. Contact us before sending your unit. We cannot store your unit!
Excalibur Electronics, Inc. reserves the right to make technical changes without notice in the interest of progress.
6
7
O
PERATING YOUR MOTORIZED BUMPER BOAT
The accelerator button is located on top of the steering
wheel. Press to activate the propeller and make the
Bumper Boat go!
Use the steering wheel to control in which direction you
move. The steering wheel can rotate 360º.
SAFETY AND CARE
• When assembling, please make sure that you tighten
the screws on the battery compartment so that water
does not get on the inside of the compartment. This
will damage the electrical system of the Bumper Boat.
• Children under 13 years of age should not operate this
product without parental supervision.
• This product is designed for pool use only. It may be
used in ponds or small lakes only within the range of
the userʼs comfortable ability to swim to
shore, provided that there are no strong currents,
waves, or water crafts present which could create
wakes. Do not use in any other body of water or in salt
water.
• This product is designed to hold one person not
exceeding 200 lbs.
• Keep hands, hair, and loose objects such as clothing
away from the propeller.
• If an object becomes lodged in the propeller, make
sure that this product is turned off before attempting to
dislodge.
• Always inspect the pool area before use to ensure it is
free of hazards and/or obstacles, such as pool toys and
swimmers.
• Never ride into or over swimmers.
• Keep this product away from hot or sharp objects.
• Always use caution and common sense.
• Never jump or dive off this product.
Accelerator
Page 5
Excalibur Electronics, Inc.
th
Avenue
Miami, Florida 33186
Phone: 305.477.8080
Fax: 305.477.9516
Play games live at:
www.ExcaliburElectronics.com
PR11 MotorBumpBoat 021207 v2
Loading...