Everspring Industry Co AC134 2 User Manual

1

AC134

IR Controller

General Introduction

The AC134 is an IR Controller based on U-Net wireless technology to control home
appliances such as TV, audio equipment and air conditioner that are typically
operated by a handheld IR remote control. Through a U-Net compatible gateway
and Homesys cloud platform, the AC134 can be programmed to substitute this
handheld remote control. This allows the user to operate home appliances from a
smartphone App even when they are not at home.

Product Layout

Accessories :

Binding with Homesys

AC134 will start pairing to the U-Net gateway when batteries are inserted into the
device.

1. First remove the back plate by undoing the screw at the side.

2. Unscrew the battery cover to expose the battery slots. Do not insert the
batteries just yet

3. Log into the Homesys account from a web browser.

4. Select “System”.

5. Select “Add a New Device”, then “IR Controller”.

Backup batteries
3 x AA

Power cable
and DC adaptor

Rubber pad

Back plate

Battery
cover

Back plate

Battery
cover

Link
button

DC power
input

IR lens

LED
indicator

2

6. The following screen will appear. This means the gateway is entering binding
mode.

7. At this point, insert the batteries into the AC134 and it will automatically bind
with the gateway.

8. The screen below will appear in 10 seconds if the process is successful.

Note: Time-out will occur if the binding process was unsuccessful. Please refer
to the “Manual Binding” in the Troubleshooting section.

IR Code Learning

The AC134 can now be programmed to learn the IR codes from the appliance’s
remote control.

1. Plug the device to the AC mains using the DC adaptor and power cable
provided while still leaving the batteries inside.

2. On the Homesys main page, select “IR controller” icon at the top.

3. In the “DEVICES” tab, click the “+” under “IR Controller”.

3

4. Then select the appliance type to learn its remote control from.

5. In this example, selecting “TV” will create an icon in the “IRREMOTE” tab for the
TV’s remote control. Click on the edit icon as shown below.

6. This brings up a virtual remote control page with icon buttons representing the
actual buttons on the remote control. To start leaning the IR code, click on a
button, for example the Power On button.

7. The red LED on AC134 will start to flash, implying that it is ready to receive up
any IR code.

8. Hold the appliance’s remote control vertically over the AC134’s lens at a close
distance of <5cm as shown below and press a button to be learned such as the
Power ON button.