EverFocus EZA2880 User Manual

EZA2880 eZ.HD Series

8MP Dual Power IP66 IR Bullet Camera

User’s Manual

Copyright © EverFocus Electronics Corp. Release Date: May, 2019 All the images including product pictures or screen shots in this document are for example only. The images may vary depending on the product and software version. Information contained in this document is subject to change without notice.

EverFocus Taiwan:

2F., No.12, Ln. 270, Sec. 3, Beishen Rd., Shenkeng Dist., New Taipei City 222, Taiwan TEL: +886 2 2662 2338 FAX: +886 2 2662 3632 www.everfocus.com.tw

128mm / 5"

280mm /

11"

91.5mm /3.6"

84mm / 3.31"

1. Introduction

Equipped with a 8MP CMOS sensor, the EZA2880 deliver 8MP image quality. The model provides motorized 3.6-11mm lens with ICR. Featured with True Wide Dynamic Range (T-WDR), the camera can provide clear images even under backlight circumstances where intensity of illumination can vary excessively. The EZA2880 supports dual power (12VDC / 24VAC, depends on model) and supports both NTSC and PAL scanning systems (auto detection).

1.1 Packing List

 Camera x 1  Mounting Sticker x 1  L-Type Wrench x 1

 Screw & Screw Anchor x 3  User Manual x 1

1.2 Features

 8MP CMOS sensor, delivering amazing high sensitivity  Motorized 3.6-11mm lens with ICR to capture the desired field of view  Extended IR range of up to 40m / 131ft. with 4 LEDs (depends on scene

IR reflectivity)

 T-WDR to improve the visibility under high contrast scene  3-Axis rotation design allows wall or ceiling mounting  IP66-rated with metal housing  Supports dual power (12VDC / 24VAC, depends on model)  Supports UTC function: Control camera OSD settings directly from DVR

end

1.3 Dimensions

BAE3201

12VDC

or 24

VAC

Power Cable

Video Output Cable

(

BNC,

Ohm

)

Mounting

Surface

Screws Screw Anchors

Camera Base

1.4 Optional Accessory

Color: White Size (Φ x H): 138 x 54mm / 5.43” x 2.16” Weight: 700g / 1.87 Material: Metal

1.5 Cable Description

2. Installation

1. Stick the supplied Mounting Sticker to the surface to mark the 3 screw positions. Drill 3 holes on the surface and insert the supplied 3 Screw Anchors into the screw holes. If you want to run the cable through the surface, drill a hole within the 3 screw area.

2. To mount the camera to the surface, screw the Camera Base to the surface using the supplied 3 Screws.

3. Connect the Power Cable to a 12VDC / 24VAC power source. Connect the Video Output Cable to a monitor or DVR.

4. You can use the Joystick on the cable to configure camera OSD settings or switch to different video formats. Remove the Protection Cap from the Joystick before using it.

+ 4 hidden pages