EverFocus EZA1840 User Manual

EZA1840 eZ.HD Series

8MP IP66 IR Bullet Camera

User’s Manual

Copyright © EverFocus Electronics Corp. Release Date: May, 2019 All the images including product pictures or screen shots in this document are for example only. The images may vary depending on the product and software version. Information contained in this document is subject to change without notice.

EverFocus Taiwan:

2F., No.12, Ln. 270, Sec. 3, Beishen Rd., Shenkeng Dist., New Taipei City 222, Taiwan TEL: +886 2 2662 2338 FAX: +886 2 2662 3632 www.everfocus.com.tw

70mm

/ 2. 76"

157mm / 6.18"

66mm / 2.6"

1. Introduction

EverFocus eZ.HD series cameras – EZA1840 is equipped with a 8MP CMOS sensor. The model provides 4mm fixed lens with ICR. Featured with True Wide Dynamic Range (T-WDR), the camera can provide clear images even under backlight circumstances where intensity of illumination can vary excessively. The EZA1840 supports both NTSC and PAL scanning systems (auto detection) and is IP66 certified.

1.1 Packing List

 Camera x 1

 Mounting Sticker x 1

 L-Type Wrench x 1

 Screw & Screw Anchor x 3

 User Manual x 1

1.2 Features

 Equipped with 8MP CMOS sensor  4mm fixed lens with ICR to capture the desired field of view  Extended IR range of up to 40m / 131ft. with 4 LEDs (depends on scene IR

reflectivity)

 T-WDR to improve the visibility under high contrast scene  The flexible angle viewing with its 3-Axis rotation design allows wall or

ceiling mounting

 IP66-rated with metal housing  Supports UTC function: Control camera OSD settings from DVR end

1.3 Dimensions

BA-E310

Color / Material: White / Metal

12VDC

Power Cable

Video Output Cable (BNC, 75Ohm)

Mounting

Surface

Screws Screw Anchors

Camera Base

1.4 Optional Accessory

Size (Φ x H): 101 x 52mm / 3.98”x 2” Weight: 540g / 1.2lb

1.5 Cable Description

2. Installation

1. Stick the supplied Mounting Sticker to the surface to mark the 3 screw positions. Drill 3 holes on the surface and insert the supplied 3 Screw Anchors into the screw holes. If you want to run the cable through the surface, drill a hole within the 3 screw area.

2. To mount the camera to the surface, screw the Camera Base to the surface using the supplied 3 Screws.

3. Connect the Power Cable to a 12VDC power source. Connect the Video Output Cable to a monitor or DVR.

4. You can use the Joystick on the cable to configure camera OSD settings or switch to different video formats. Remove the Protection Cap from the Joystick before using it.

+ 4 hidden pages