EverFocus EZA1540 User Manual
EZA1540 eZ.HD Series
5MP IP66 IR Bullet Camera
User’s Manual
Copyright © EverFocus Electronics Corp.
Release Date: May, 2019
All the images including product pictures or screen shots in this document are for example
only. The images may vary depending on the product and software version. Information
contained in this document is subject to change without notice.
EverFocus Taiwan:
2F., No.12, Ln. 270, Sec. 3, Beishen Rd., Shenkeng Dist., New Taipei City 222, Taiwan
TEL: +886 2 2662 2338 FAX: +886 2 2662 3632 www.everfocus.com.tw
70mm
/ 2.
76"
157mm / 6.18"
66mm / 2.6"
1. Introduction
EverFocus eZ.HD series cameras – EZA1540 is equipped with a 5MP SONY
STARVI S CMOS sensor. The model provides 3.6mm fixed lens with ICR. Featured
with True Wide Dynamic Range (T-WDR), the camera can provide clear images
even under backlight circumstances where intensity of illumination can vary
excessively. The EZA1540 supports both NTSC and PAL scanning systems and is
IP66 certified.
1.1 Packing List
Camera x 1
Mounting Sticker x 1
L-Type Wrench x 1
Screw & Screw Anchor x 3
User Manual x 1
1.2 Features
Equipped with SONY STARVIS 5MP CMOS sensor
3.6mm fixed lens with ICR to capture the desired field of view
Extended IR range of up to 25m / 82ft. with 20 LEDs (depends on scene IR
reflectivity)
T-WDR to improve the visibility under high contrast scene
The flexible angle viewing with its 3-Axis rotation design allows wall or
ceiling mounting
IP66-rated with metal housing
Supports UTC function: Control camera OSD settings from DVR end
1.3 Dimensions
1
2
BA-E310
Color / Material: White / Metal
12VDC
Power Cable
Video Output Cable (BNC, 75Ohm)
Mounting
Surface
Screws Screw Anchors
Camera Base
1.4 Optional Accessory
Size (Φ x H): 101 x 52mm / 3.98”x 2”
Weight: 540g / 1.2lb
1.5 Cable Description
2. Installation
1. Stick the supplied Mounting Sticker to the surface to mark the 3 screw
positions. Drill 3 holes on the surface and insert the supplied 3 Screw Anchors
into the screw holes. If you want to run the cable through the surface, drill a
hole within the 3 screw area.
2. To mount the camera to the surface, screw the Camera Base to the surface
using the supplied 3 Screws.
3. Connect the Power Cable to a 12VDC power source. Connect the Video
Output Cable to a monitor or DVR.
4. You can use the Joystick on the cable to configure camera OSD settings or
switch to different video formats. Remove the Protection Cap from the
Joystick before using it.
Loading...