EverFocus EZ600-B, EZ600-W User Manual

EZ600/W

EZ600/B

HIGH PERFORMANCE

BULLET CAMERA

OPERATION MANUAL

Before attempting to connect or operate, please read and
follow these instructions.

CAUTIONS

This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions;

1. This device may not cause harmful interference.

2. This device must accept any interference received, including
interference that may cause undesired operation.

Note -

This equipment has been tes ted and found to comply with the lim its for a
Class A digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is opera ted in a comme rcial envi ronment. T his equip ment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordan ce with the i nstruction manual, may ca use harmf ul
inter ference to r adio c ommunica tions. Operatio n of this equipme nt in a
residential area is likely to cause harmful interference in which case the user
will be required to correct the interference at his own expense.”

WARNING -

This is a class A product. In a domestic environment this product may cause
radio interference in which case the user may be required to take adequate
measures.

Caution -

Do not make any changes to the houseing or internal parts. This could void

the FCC certication and may void the warranty.

1. IF DC power is used regulated DC12V 500mA power supply is
recommended for use with this camera for the best picture and the most
stable operation.

An unregulated power supply may cause damage to the camera.
If an unregulated power supply is used, product warranty may be void.

2. It is recommended that the camera is used with a monitor that has

a CCTV quality 75Ω video impedance level. If your monitor or other

equipment is switched to high impedance then please adjust accordingly.

3. Do not attempt to disassemble the camera to gain access to the internal
components. Refer servicing to the manufacturer

4. Never face the camera towards the sun or any bright or reective light,

which may cause smear on the picture and possible damage to the CCD.

5. Do not remove the serial number sticker.

CAUTION

CAUTIONS

Correct Disposal of This Product

(Waste Electrical & Electronic Equipment)

(Applicable in the European Union and other European
countries with separate collection systems)

This marking shown on the product or its literature, indicate that
it should not be disposed with other household wastes at the end
of its working life. To prevent possible harm to the environment or
human health from uncontrolled waste disposal, please separate
this from other types of wastes and recycle it responsibly to promote
the sustainable reuse of material resources.

This product should not be mixed with other commercial wastes

purchased this product, or their local government ofce, for details

of where and how they can take item for environmentally safe
recycling.

Business users should contact their supplier and check the terms
and conditions of the purchase contract.
Household users should contact either the retailer where they for
disposal.

RISK OF ELECTRIC SHOCK DO NOT OPEN

CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO

NOT REMOVE COVER(OR BACK). SERVICING MUST
BE DONE BY QUALIFIED SERVICE PERSONNEL.

This symbol is intended to alert the user to the presence
of uninsulated "dangerous voltage" within the product's

enclosure that may be of sufcient mangnitude to constitute

a risk of electric shock to persons.

This symbol is intended to alert the user to the presence of
important operating and maintenance(servicing) instruction in
the literature accompanying the appliance.

CAUTION

FEATURES

• 1/3" Sony Super-HAD CCD

Minimum illumination 0.00002 Lux

( F1.2, 30 IRE, Sense-up X256, AGC high ) S/N Ratio 50dB

• High Resolution 600TV Lines

This camera displays a high resolution of 600 TV Lines using
sophisticated full digital image processing, 10 bit A/D serial signal
processing and special algorithm technologies.

• 3D DNR (3D Digital Noise Reduction)

The DNR technology greatly reduces noise thus delivering a crisp
and clear image.
This camera’s DNR function utilizes an adaptive 3D Filter to reduce
noise caused by movement and the evironment.

• DAY&NIGHT

The Day & Night operation feature an ‘auto’ mode which switches
between color and B&W modes automatically based on the level
of illumination in the scene. The COLOR mode operates during
bright conditions to provide optimum colors while the B&W Mode

operates during dark conditions to enhance the denition of the

image. Or, the camera may be set to return a color image at all
light levels.

• Privacy Mask Function

The Privacy masking feature allows for the ‘blanking’ of specic

areas in a scene where viewing or recording is prohibited or not
desired.

• OSD (On Screen Display)

This camera is easily congured with its OSD (On Screen Display),

menu. The menu can be displayed in multiple languages.

Ⅱ

COMPONENTS

Bullet
Camera

Mounting
Bracket

Mounting

Screw 3ea

Power
Pigtail Cable

Operation
Manual

MOUNTING POSITION DIMENSIONS

360

˚

360

˚

90

˚

CONNECTION

DC12V/AC24V

(RED)

1/4"-20 UNC

Depth 4.5(0.18)

Joystick for OSD

When you install the camera, please seal the ends of
cables to protect the camera coneections from humidity
problems.

BNC FEMALE

VIDEO IN

DC12V POWER SUPPLY /
AC24V POWER SUPPLY

TV MONITOR

OR DVR

Unit: mm(inch)

36(Ф1.41)

Ф

33.5(1.32)

29(

Ф

Ф1.14)

Ф

Focus Ring

(NEARFAR)

60(Ф2.36)

Mount

133(5.23)

Camera with sunshield

124(4.88)

51.2(2.02)

Zoom Ring

(WideTele)

Camera body only

41.5(1.63)

Mounting base pattern

3-Ф

4.5(0.11-

36 (1.41)

Ф0.18)

SPECIFICATION

Signal Format NTSC PAL

Image Device 1/3" Sony Super HAD CCD

Total Pixels

Effective
Pixels

Inter. H/V 15,734/59.94Hz 15,625/50Hz

H.Resolution 600TV Lines

Minimum
illumination

S/N Ratio More than 50dB (AGC Off)

Electronic
Shutter

Manual

Shutter

Sense-up X2, X4, X8, X16, X32, X64, X128, X256 (8X Recommended)

AGC Off / Low / Middle / High

White
Balance

Sync
System

Privacy Zone 8 Zone

Flickerless OFF/ON

Lens varifocal (f3.5 ~ 16.0mm)

3DNR Off / On (Plus Level setting)

Motion
Detection

Language

Additional

DSP

Functions

Video Output CVBS

Input Power

Source

811(H) x 508(V)

approx.410K pixels

768(H) x 494(V)

approx. 380K pixels

0.00002 Lux / F1.2 ( Sense- up )

1/60 ~ 1/100.000 sec 1/50 ~ 1/100.000 sec

1/60(50), FLK, 1/250, 1/500, 1/2K, 1/5K, 1/10K, 1/100K

X2, X4, X8, X16, X32, X64, X128, X256

ATW / PUSH / PUSH-LOCK / MANUAL / INDOOR / OUTDOOR

English, French, Russian,German, Spanish, Dutch

Mirror(H,V,H/V), Digital Zoom, Freeze,Negative Image, BLC, D-WDR

DC12V ±10% Max 170mA

AC24V ±10% Max 1.8W

Internal

4 Areas

Ⅱ

795(H) x 596(V)

approx. 470K pixels

752(H) x 582(V)

approx. 440K pixels

OSD MANUAL

GENERAL STRUCTURE

SETUP MENU

EXPOSURE

WHITE BAL

DAY&NIGHT •COLOR •B/W •AUTO

IMAGE

3DNR •LEVEL •RETURN

SPECIAL

RESET •FACTORY RESET

EXIT

•SHUTTER • BRIGHTNESS •AGC

•SENSE-UP • BLC •D-WDR

•ATW •PUSH •PUSH-LOCK

•MANUAL •INDOOR •OUTDOOR

•FREEZE •MIRROR •D-ZOOM

•SHARPNESS •COLOR GAIN

•GAMMA •NEG.IMAGE

•CAM TITLE •LANGUAGE

•MOTION •PRIVACY

UP

LEFT

DOWN

Press in on joystick for

enter/select

MENU

(SELECTION KEY)

RIGHT

OSD MANUAL

OSD FUNCTION DESCRIPTION

1. EXPOSURE

: Enables the user to congure the following functions:
SHUTTER, AGC, SENSE-UP,
BLC, D-WDR

- SHUTTER

• AUTO : Exposure is controlled

automatically.

• FLK : Enable FLICKERLESS.
(NTSC: 1/100, PAL: 1/120)

• FIXED : Allow the shutter speed to be set manually.
> 1/60(50), 1/250, 1/500, 1/2K, 1/5K, 1/10K, 1/100K

* ( ) is for PAL TYPE

- BRIGHTNESS : AUTO Mode Only.

- AGC : Low, Middle, High.

*If AGC feature is turned off,
3D-DNR & SENS-UP Features will not be available.

- SENSE-UP : Slow shutter speed control
(max of 8~16 recommended).

- BLC : Back Light Compensation.

• HSBLC : Highlight Suppression BLC will darken

bright parts of the image.

- D-WDR : Allows accurate display of images during high contrast

lighting conditions.

EXPOSURE

SHUTTER AUTO
BRIGHTNESS 50
AGC OFF
SENSE-UP AUTO

BLC BLC

D-WDR OFF
RETURN RET

┛

┛

OSD MANUAL

2. WHITE BALANCE

: Enable the user to set the White Balance through controlling R,G,B

Levels.

WHITE BAL MANUAL

BLUE 24
RED 32
RETURN RET

• ATW : White Balance is traced automatically through a wide

range of color temperatures.

(2,500K ~ 9,500K)

• PUSH : White Balance is automatically adjusted for the current

color temperature.

• P-LOCK : White Balance is Fixed to the current state.
White Balance will be readjusted everytime this

function is used.

• MANUAL : Enable the manual adjustment of RED
GAIN and BLUE GAIN.

• INDOOR : White Blance is automatically adjusted at 3,200K base

color temperature.

• OUTDOOR : White Blance is automatically adjusted at 5,400K

base color temperature

┛

OSD MANUAL

3. DAY&NIGHT

: Switching the output image from COLOR when in a bright

environment to B&W when dark.

DAY & NIGHT AUTO

DWELL TIME 10sec

DN LEVEL 4

ND LEVEL 6

RETURN RET

- AUTO : Color or B/W mode auto change.

• DETECT MODE
VIDEO : Select to detect mode as level of VIDEO.

• DWELL TIME :
Duration of continuous lighting condition (Bright or Dark) before

switching mode.

(0~10 SEC).

• D>N LEVEL : The Level where the change occurs from
COLOR(Day) to BW(Night).

• N>D LEVEL : The Level where the change occurs from
BW(Night) to COLOR(Day).

- B/W : Image output is xed at B&W.

• BURST ON/OFF : Select the burst signal ON/OFF when Night

condition.

- COLOR : Enables user to x the output image in COLOR at all

light levels.

┛

OSD MANUAL

4. IMAGE

: Congurations for the following settings: FREEZE, MIRROR,
D-ZOOM, SHARPNESS, COLOR GAIN, GAMMA, NEGATIVE
IMAGE.

- FREEZE : Freezes the output image(use requires real time access
to the camera controls).

- MIRROR

• MIRROR : Output image is mirrored (Left to Right).

• V-FLIP : Output image is ipped vertically (Up and Down).

• ROTATION : Output image is rotated 180-degrees.

- D-ZOOM : Digitally Zooms in on a section of the screen.

- SHARPNESS : Sharpness of the output image can be adjusted.

- COLOR GAIN : RED GAIN or BLUE GAIN can be adjusted.

- GAMMA : Gamma vaule can be set.

- NEG.IMAGE : Output image is coverted to a negative image.

5. 3DNR

: Three-dimensional Noise Reduction.

- LEVEL : The degree of noise

reduction can be set.

IMAGE

FREEZE OFF

MIRROR OFF

D-ZOOM ON
SHARPNESS 5
COLOR GAIN
GAMMA 0.45
NEG.IMAGE OFF
RETURN RET

┛

┛

┛

3DNR

LEVEL 50
RETURN RET

OSD MANUAL

6. SPECIAL

: Congurations for the following settings: CAM TITLE, LANGUAGE,
MOTION, PRIVACY.

SPECIAL

CAM TITLE OFF
LANGUAGE ENGLISH

MOTION ON

PRIVACY ON
RETURN RET

- CAMERA TITLE : Displays the title editing menu.

- LANGUAGE : The Language to display the OSD in,
(English, Russian, Spanish, German, French, Dutch).

- MOTION : The camera will monitor the output image for motion

and display a OSD Icon uppon detection.

• AREA SELECT : 4 areas can be selected for motion detection.

• AREA DISPLAY : Areas of motion detection can be toggled

on and off

• LEFT/RIGHT : Moves the detection area left and right.

• WIDTH : The width of the detection area is set.

• TOP/BOTTOM : Moves the detection area up and down.

• HEIGHT : he height of the detection area is set.

• SENSITIVITY : Level of sensitivity for detecting motion is set.

• MOTION VIEW : Displays the areas of motion on the screen.

┛

┛
┛

┛

OSD MANUAL

- PRIVACY : Up to 8 areas of the output image can be obscured.

• AREA SELECT : Select up to 8 areas.

• AREA DISPLAY : Displays the masked areas.

• LEFT/RIGHT : Moves the pricacy area rght and left.

• WIDTH : The width of the privacy area is set.

• TOP/BOTTOM : Moves the pricacy area rght and left up and

down.

• HEIGHT : the height of the privacy area is set.

• COLOR : Color to use for the mask is set.

7. RESET

: Returns the camera to its factory default.

RESET

FACTORY RESET
RETURN RET

┛

┛