EverFocus EMF917F User Manual

EMF917F

2MP, 180°, IP68 AHD Mobile IR Fisheye Camera

User’s Manual

Copyright © EverFocus Electronics Corp,

Release Date: July, 2018

All the images including product pictures or screen shots in this document are for example only. The
images may vary depending on the product and software version. Information contained in this
document is subject to change without notice.

Precautions

1. Do not install the camera near electric or magnetic fields. Install the camera away from

TV/radio transmitters, magnets, electric motors, transformers and audio speakers since the
electromagnetic fields generated from these devices may distort the video image or otherwise
interfere with camera operation.

2. Never disassemble the camera beyond the recommendations in this manual nor introduce

materials other than those recommended herein. Improper disassembly or introduction of
corrosive materials may result in equipment failure or other damage.

3. Try to avoid facing the camera toward the sun. In some circumstances, direct sunlight may

cause permanent damage to the sensor and/or internal circuits, as well as creating unbalanced
illumination beyond the capability of the camera to compensate.

4. Keep the power cable away from water and other liquids and never touch the power cord

with wet hands. Touching a wet power cord with your hands or touching the power cord with
wet hands may result in electric shock.

5. Never install the camera in areas exposed to oil, gas or solvents. Oil, gas or solvents may result

in equipment failure, electric shock or, in extreme cases, fire.

6. Cleaning. For cameras with interchangeable lenses, do not touch the surface of the sensor

directly with the hands. Use lens tissue or a cotton tipped applicator and ethanol to clean the
sensor and the camera lens. Use a damp soft cloth to remove any dirt from the camera body.
Please do not use complex solvents, corrosive or abrasive agents for cleaning of any part of the
camera.

7. Do not operate the camera beyond the specified temperature, humidity or power source

ratings. This camera is suitable for indoor operation only. Use the camera at temperatures
within -30°C~50°C (-22°F~131°F) and humidity less than 80%; this device is not rated as
submersible. The input power source is 12VDC. Be sure to connect the proper + / - polarity and
voltage, as incorrect polarity or too high a voltage will likely cause the camera to fail, and such
damage is not covered by the warranty.

8. Mounting. Use care in selecting a solid mounting surface which will support the weight of the

camera plus any wind, snow, ice or other loading, and securely attach the camera to the
mounting surface using screws and anchors which will properly support the camera. If
necessary (e.g. when mounting to drop ceilings) use a safety wire to provide additional support
for the camera.

1

Safety Notice

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.

- Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.

2

1. Introduction

Camera x 1

Screw x 4

Tor x Wrench x 1

Anchor x 4

Installation Sticker x 1

User Manual x 1

EverFocus’ EMF917F is a fisheye camera, supporting 2MP full HD image quality. The camera comes
with a 1.72mm fisheye lens, providing 180° viewing angle. EMF917F features 4 LEDs, which enable
night vision up to 10m (~33ft.). The camera is IP68-certified and supports both NTSC and PAL
scanning systems. The camera provides 3 types of cable, please select either one best suit your
system before shipping.

EMF917F Product Selection:

Viewing Angle Scanning System Cable Type PN

BNC + 12VDC Power 2W09170FNB0001R

180°

1.1 Packing List







NTSC

PAL

M12 2W09170FNB0005R
Mini DIN 2W09170FNB0002R
BNC + 12VDC Power 2W09170FPB0001R
M12 2W09170FPB0005R
Mini DIN 2W09170FPB0002R







1.2 Features

 1080p full HD with high flexibility and performance for astounding image
 1080p CMOS sensor, delivering amazing high sensitivity
 180°horizontal wide angle
 Astounding image quality from the fisheye lens
 Extended IR range up to 10m / 33ft. with 4 LEDs (depends on scene IR reflectivity)
 Supports HW De-warp
 True Day/Night with ICR
 IP68 weather resistant

3

With Bracket

Without Bracket

71mm / 2.8"

61.8mm / 2.43"

65mm / 2.56"

68.6mm / 2.7"

53.55mm / 2.11"

49.74mm / 1.96"

1.3 Cable Description

The EMF917F provides 3 types of cable, please select either one before shipping.

 BNC (1Vp-p, 75Ω) + 12VDC Power
 M12 (transmit both video signal and power)
 Mini DIN (transmit both video signal and power)

M12 PIN Define

1 2 3 4

Mini DIN PIN Define

3. Installation

DC+ DC- NC TV Out

1 2 3 4 5 6 7 8

DC+ DC-

Video

Out

NC NC GND NC NC

3.1 Dimensions

4

Ø5.20mm

For Top Mounting

Mounting Surface

Ø5.20mm

For Rear Mounting

Mounting Surface

3.2 Mounting the Camera

There are 2 ways to mount the camera onto the surface: Top Mounting and Rear Mounting.

Top Mounting:

Stick the Installation Sticker onto the surface and mark the two screw hole positions on the
surface. Drill two screw holes on the surface and insert the supplied two Anchors to the holes.
Remove the sunshield from the camera (refer to 3.4 Removing Sunshield) and screw the
sunshield to the surface using the supplied two Screws. Screw the camera back to the
sunshield.

Rear Mounting:

Stick the Installation Sticker onto the surface and mark the four screw hole positions on the
surface. Drill four screw holes on the surface and insert the supplied four Anchors to the holes.
Remove the sunshield from the camera (refer to 3.4 Removing Sunshield) and screw the
sunshield to the surface using the supplied four Screws. Screw the camera back to the
sunshield.

5

0°

90°

3.3 Adjusting Camera Angle

You can adjust camera tilting angle by 90°. To do this, loosen the lower screws on both side of

the camera using the supplied Torx Wrench and then adjust the angle. Tighten the screw after
adjusting angle.

3.4 Removing Sunshield

To remove the sunshield from the camera for installation, remove the four screws on both side
of the camera using the supplied Torx Wrench and then remove the sunshield.

6

Power

EverFocus Taiwan:

EverFocus China - Shenzhen:

EverFocus China - Beijing:

EverFocus Japan:

[e-mail]

EverFocus USA - California:

Your EverFocus product is designed

Ihr EverFocus Produkt wurde entwickelt

P/N: 4605W091702001A

5. Specification

Model No. EMF917F

Pickup Device 1/2.8" Sony 2MP CMOS Sensor Day / Night Supported

Video Format NTSC / PAL De-warp Supports HW de-warp

Effective Pixels 1920 (H) x 1080 (V) Scanning System Progressive Scan
Sensitivity 0 Lux with IR On Power Source 12VDC

Unit Cell Size 2.9 μm×2.9μm

Consumption

6W max.

Lens Type 1.72mm Fisheye Lens Environmental IP68 Weather Resistant

Lens F.O.V. H:180°, F:2.0 Humidity Less than 80%

Cable Types
(Selectable)

BNC (1Vp-p, 75Ω) + Power
M12 (video signal & power)
Mini DIN (video signal & power)

Dimensions
(H x W x D)

71 x 61.8 x 65mm /

2.8” x 2.43” x 2.56”
(with Bracket)

IR LEDs 4 IR LEDs Weight 226g / 0.5lb

IR Distance

Up to 10m / 33ft.
(depends on scene IR reflectivity)

Operating
Temperature

0°C ~ 55°C / 32˚F~131˚F

Certificates CE, FCC, E-Mark, EN50155, RoHS

EverFocus Electronics Corp.

2F., No.12, Ln. 270, Sec. 3, Beishen
Rd., Shenkeng Dist., New Taipei
City 222, Taiwan
TEL: [phone]
FAX: [phone]
www.everfocus.com.tw

[e-mail]

3F,Building 7,Longcheng Industrial
Park,No.440,Longguan Road,
Dalang Street, Longhua, Shenzhen,
Guangdong, China
TEL: [phone]
FAX: [phone]
www.everfocus.com.cn

[e-mail]

Room 609, Technology Trade
Building,
Shangdi Information Industry Base,
Haidian District, Beijing 100085,
China
TEL: [phone]~39
FAX: [phone]
www.everfocus.com.cn

[e-mail]

3F, Kuramochi, Building II
2-2-3 Koto-Bashi, Sumida-Ku,
Tokyo, 130-0022, Japan
TEL: [phone]
FAX: [phone]
www.everfocus.co.jp

and manufactured with high qua lity
materials and compone nts which can
be recycled and reused.
This symbol means that electrical and
electronic equipment, at their
end-of-life, should be disposed of
separately from your household waste.
Please, dispose of this equipment at
your local community waste
collection/recycling centre.
In the European Union there are
separate collection systems for used
electrical and electroni c product.
Please, help us to conserve the
environment we live in!

1801 Highland Avenue, Unit A,
Duarte, CA 91010, USA
TEL: [phone]
FAX: [phone]
www.everfocus.com

[e-mail]

und hergestellt mit qualitativ
hochwertigen Materia lien und
Komponenten, die recycelt und wieder
verwendet werden können.
Dieses Symbol bedeutet, dass
elektrische und elektronische Geräte am
Ende ihrer Nutzungsd auer vom
Hausmüll getrennt entsorgt werden
sollen.
Bitte entsorgen Sie dieses Gerät bei
Ihrer örtlichen kommuna len
Sammelstelle oder im Recycling Centre.
Helfen Sie uns bitte, die Umwelt zu
erhalten, in der wir leben

!

7