EverFocus EHN3200 User Manual

EHN3200

User’s Manual

Copyright © EverFocus Electronics Corp,

Release: Apr. 2011 Rev. 0

EHN3200

Product Name: EHN3200 EverFocus IP Network Cameras

Model Number(s): EHN3200

FCC Notice "Declaration of Conformity Information"

This equipment has been tested and found to comply with the limits for a Class

A digital device, pursuant to part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference in a residential

Installation. This equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

Warning: Changes or modifications made to this equipment, not expressly approved

by EverFocus or parties authorized by EverFocus could void the user's authority to

operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that

may cause undesired operation.

EverFocus Electronics Corp.

12F, No. 79, Sec. 1, Shin-Tai Wu Rd., His-Chi,

Taipei Hsien, Taiwan, R.O.C.

EHN3200 complies with CE and FCC rules.

2

EHN3200

About this document

All the safety and operating instructions should be read and followed before the

unit is operated. This manual should be retained for future reference. The

information in this manual was current when published. The manufacturer reserves

the right to revise and improve its products. All specifications are therefore subject

to change without notice.

Safety Notices

-These limits are designed to provide reasonable protection against interference.

This equipment may generates, uses and can radiate radio frequency energy and, if

not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase these separations between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

Any changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

To reduce risk of fire or electric shock, do not expose this camera to rain or

moisture.

Do not attempt to disassemble the camera. To prevent electric shock, do not

remove screws or covers. There are no user-serviceable parts inside. Contact

qualified service personnel for maintenance. Handle the camera with care. Do not

strike or shake, as this may damage the camera.

Do not use strong or abrasive detergents when cleaning the camera body. Use

a dry cloth to clean the camera when it is dirty. When the dirt is hard to remove,

3