EverFocus ED100 Operation Manual

B/W CCD Camera

INSTRUCTION
MANUAL

Important Safeguards

 Read all of these instructions.

Save these instructions for later use.

All warnings on the products and in the operating instructions

should be adhered to.

Unplug this appliance system form the wall outlet before
cleaning. Do not use liquid cleaners or aerosol cleaners, use a
damp cloth for cleaning.

Do not use attachments not recommended by the appliance
manufacturer as they may cause hazards.

Do not use this appliance near water, for example, near a
bathtub, washbowl, kitchen sink, or laundry tub, in a wet
basement,or near a swimming pool,etc.

Do not allow anything to rest on the power cord. Do not
locate this appliance where the cord will be abused by persons
walking on it.

1

Follow all warnings and instructions marked on the appliance.

Do not overload wall outlets and extension cords as this

can result
in fire or electric shock.

Never push objects of any kind into his appliance through
cabinet slots as they mat touch dangerous voltage points or short
out parts that could result in fire or electric shock.

Do not place this appliance on an unstable cart, stand,or table.

The appliance may fall, causing serious injury to a child or

adult, and serious damage to the appliance. Use only with a cart
or stand recommended by the manufacturer,or sold with the
appliance. Wall or shelf mounting should follow the
manufacturer’s instructions, and should use a mounting kit
approved by the manufacturer. An appliance and cart combination
should be moved with care, Quick stops, excessive force,

2

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION TO REDUCE THE RISK OF ELECTRIC SHOCK.

REFER SERVICING TO QUALIFIED SERVICE PERRSONNEL.

The lightning flash with an arrowhead symbol, within an
equilateral triangle, is intended to alert the user to the presence
of uninsulated ” dangerous voltage” within the product’s enclosure
that may be of sufficient magnitude to constitute a risk of electric
shock to persons

This symbol is intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in the literature
accompanying the appliance.

DO NOT REMOVE COVER ( OR BACK).

NO USER SERVICEABLE PARTS INSIDE.

3

Note:

This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection. This equipment generates,
uses and can radiated radio freque ncy energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation If this equipment does cause
harmful interference to radio or television reception, which can be
determined
by turning the equipment off and on, the user is encour aged to try to correct
the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase these paration between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

The changes or modifications not expressly approved by the party
responsible

for compliance could void the user's authority to operate the equipment.

4

I. General

This Camera is a compact, full functioned CCD Camera. Its
stylish appearance can be applied as per installer's ideal locations.
These dome cameras can be mounted either on the ceiling or on
the wall easily. This camera uses high sensitive 1/3" Sony B/W
CCD sensor with DSP. The sensor is featured with Auto Electronic
Shutter, Automatic Gain Control.

II. Precautions

• Do not expose the camera to humidity and dust. Outdoor

application without shielding is not recommended.

• Handle with care. This camera consists of sensitive high

precision parts. Do not disassemble or install it on an
unstable base.

• Operate on +12VDC. Use a regulated power source only.

• The external adapter is optional

• Never face the camera toward the sun directly.

5

III. Lens Available

* Standard board lens f=3.6 mm, F=2.0 mm.
* Other available lens : Lens f=2.5 mm, F=2.0 mm

Lens f=4.3 mm, F=2.0 mm
Lens f=6.0 mm, F=2.0 mm
Lens f=8.0 mm, F=2.0 mm

VI. Installation Instructions

1. Remove the plastic dome cover.

2. Loosen the two screws of the supporting bracket to remove
the camera body.

3. Using four screws to fix the camera base on the ceiling.

4. Put the camera body back to the supporting bracket, the
connector of the back panel should always be the

6

a. Floor Mount

b. Ceiling Mount

c. Wall mount,

aim to the right

d. Wall mount,

aim to the left

• Connect the BNC connector of the camera to a
monochrome monitor, or other video device through
a 75 ohm type coaxial cable with BNC female
connector at cable extension.

7

• Connect the +12VDC regulated power source of
the camera (DC Jack) to the 12VDC Power-in
jack with 2 mm, center+, outer- plug.

7. Once the image appears on the monitor, loosen the
fixing screw located at the lens mount then adjust
the focus and diaphragm of the lens to obtain the
best picture. When the ideal picture is obtained,
secure the lens mount fixing screw firmly again.

8. Put the plastic cover back on
the Dome Camera.

8

IV. Specifications

Picture Elements

1/3" SONY B/W CCDPickup Device
510 x 492(EIA)

500 x 582(CCIR)
420 TV lines Horizontal Resolution

0.04 Lux /F=1.2Sensitivity
Over 48 dB (AGC off)S/N Ratio
1/50(1/60)~1/100,000Electronic Shutter

0.45Gamma Correction
BNC 1.0Vp-p,75 ohmVideo Output
Internal Sync.Sync. Mode
M12 x P0.5Lens Mount
12VDCPower Source
3W max. Power Consumption
108 mm (O.D.) x 80 mm (H) ; 4.3”(O.D) x 3.2” (H)Dimensions
0°C to +50°C ;32°F~122°F (20%~80% Humidity)Operating Temperature

FCC/CE Certifications

9

V.Package Contents

• One Camera unit

• User’s manual

Your EverFocus product is designed
and manufactured with high quality
materials and components which can
be recycled and reused.
This symbol means that electrical
and electronic equipment, at their
end-of-life, should be disposed of
separately from your household
waste.
Please, dispose of this equipment at
your local community waste
collection/recycling centre.
In the European Unio n there are
separate collection system s for used
electrical and electronic product.
Please, help us to conserve the
environment we live in!

Ihr EverFocus Produkt wurde
entwickelt und hergestellt mit
qualitativ hochwertigen Materialien
und Komponenten, die recycelt und
wieder verwendet werden können.
Dieses Symbol bedeutet, dass
elektrische und elektronische Gerät e
am Ende ihrer Nutzungsdauer vom
Hausmüll getrennt entsorgt werden
sollen.
Bitte entsorgen Sie dieses Gerät bei
Ihrer örtlichen kommunalen
Sammelstelle oder im Recycling
Centre.
Helfen Sie uns bitte, die Umwelt zu
erhalten, in der wir leben!

10

MED1G01400 VerA