Everdure OBES62 Installation Manual

INSTALLATION

The adjacent furniture must be able to withstand a minimum temperature rise of 50°C above the
ambient temperature of the room it is located in, during periods of use. The power supply to the
appliance must be cut off before any adjustments or maintenance work is done on it.

PREPARATION FOR INSTALLATION AND USE

Manufactured with best quality parts and materials, this modern, functional and practical oven will meet your
needs in all respects. Make sure to read the manual to obtain successful results so as not to experience any
problems in the future. The information given below contains rules that are necessary for correct positioning
and service operations. They should be read without fail, especially by the technician who will position the
appliance.

CHOOSING A PLACE FOR THE APPLIANCES
There are several points to pay attention to when choosing a place for your oven. Make sure to take into
account our recommendations below in order to prevent any problems and dangerous situations, which
might occur later!
When choosing a place for the oven, attention should be paid that there are no flammable or combustible
materials in the close vicinity, such as curtains, oil, cloth etc. which quickly catch fire.
Furniture surrounding the oven or cooktop must be made of materials resistant to temperatures above 50 C°.
Required changes to wall cabinets and exhaust fans above a built-in cooktop as well as minimum heights
from the oven board are shown in Figure 1. Accordingly, the exhaust fan should be at a minimum height of
65 cm from the cooktop. If there is no exhaust fan the height should not be less than 70 cm.

6

DESIGNED TO PERFECTION

INSTALLATION OF BUILT IN OVEN

Insert the oven into cabinet partly by pushing it forward. Open the oven door and insert 2 screws into the
holes on the oven frame. While the product frame touches the wooden surface of the cabinet, tighten the
screws.
The dimensions and material of the cabinet in which the oven will be installed must be correct and resistant
to increases in temperature. In a correct installation, contact with electrical or insulated parts must be
prevented. Insulating parts need to be fitted in a way to ensure that they cannot be removed by using any
kind of tool. Installing the appliance in the close vicinity of a refrigerator or a deep-freezer is not
recommended as the performance of the above-mentioned appliances will be negatively affected due to
emanating heat. After removing your oven from its packaging, be sure that the oven is not harmed. In case,
you suspect of any damage to the appliance, do not use it; immediately contact an authorized Service
Centre.

DESIGNED TO PERFECTION

7