Everdure NEO GRANDE ESEE, NEO GROSSO ESEE Instruction Manual

ASSEMBLY, OPERATION

& MAINTENANCE INSTRUCTIONS

NEO GRANDE ESEE & GROSSO ESEE

FOR OUTDOOR USE ONLY

here barbecuing meets art

ASSEMBLY, OPERATION AND MAINTENANCE INSTRUCTIONS

FOR EVERDURE 6 BURNER GAS BARBECUE RANGE

GRANDE ESEE AND GROSSO ESEE OUTDOOR BARBECUES

CONTENTS

SECTION PAGE NO.

General Safety Instructions 3 Appliance Details 4 Gas Connections 4 Outdoor Installation Guide 5 Operating Instructions for Barbecue 6 Lighting Procedure 6 Cooking 7 Cleaning and Storage 7 Operating Instructions for Wok Burner 8 Esee Light System Instructions 8 Troubleshooting 9 Maintenance 9 Assembly Instructions 10-16

It is important that you retain these instructions for future reference.

Grande Esee

IMPORTANT SAFETY INSTRUCTIONS (GAS)

IMPORTANT: Read the assembly instruction section and safety precautions of this booklet carefully

before removing the contents of this carton.

1. This barbecue and wok burner is for OUTDOOR USE ONLY. This appliance must NOT be used indoors.

2. Unsupervised children or pets should not be near a barbecue while cooking or during warm up or cool down.

Ensure children or pets are kept a distance well away from the barbecue whilst it is in use. Ensure that young children do not play with the appliance.

3. Particular care must be taken when removing the fat tray. Hot fats can cause serious injury.

4. Turn all gas valves off including cylinder after use. Do not allow build up of unburned gas.

5. Do not use this appliance for any purpose other than what it is intended for.

6. Do not move this barbecue while in use as accessible parts may be very hot.

7. People with flammable clothing such as nylon etc. should keep well away from the barbecue when it is

operating.

8. Never leave burners on high for more than 10 minutes unless actually cooking.

9. Always check for leaks when a gas cylinder is replaced or reconnected.

10. Sand, kitty litter and fat absorbers should not be used in the fat tray.

11. In case of fat fire turn cylinder off. Fat drip trays should be cleaned and checked before using the barbecue.

Regular cleaning should reduce the build up of fat and food residues which is combustible and can result in a fat fire. Fat fires can be prevented with diligence in cleaning your fat tray. Damage as a result of fat fire is not covered by your warranty and voids it.

12. For your safety and enjoyment, read all operating instructions before lighting.

13. Ensure that the product has adequate clearance from combustible materials. The appliance is designed so that

heat will not affect the trolley. All combustible materials must be kept more than 250mm from the sides of the trolley and more than 1500mm above the cooking surface of the barbecue.

14. If the burner makes a hissing sound when lit, it may be burning inside. Turn the burner off, allow to cool, and try the

ignition again. Keep your barbecue protected against strong wind – if this cannot be avoided, always check that the burners remain alight if operating the barbecue in windy conditions.

15. This appliance is not intended for use by young children or infirm persons.

16. When the wok burner is in use or is still hot, the lid must not be placed in the closed position.

17. Do not carry out any servicing on the gas manifold of the barbecue yourself – this must only be done by authorised

technicians.

18. We recommend that you regularly maintain your barbecue and keep it in good condition. This can be achieved by

following the cleaning and maintenance suggestions in this booklet.

DO NOT OPERATE THIS APPLIANCE BEFORE READING THE INSTRUCTION BOOKLET DO NOT PLACE ARTICLES ON OR AGAINST THIS APPLIANCE DO NOT STORE CHEMICALS OR FLAMMABLE MATERIALS OR SPRAY AEROSOLS NEAR THIS APPLIANCE

DO NOT OPERATE THIS APPLIANCE INDOORS DO NOT ENCLOSE THIS APPLIANCE

IMPORTANT SAFETY INSTRUCTIONS (ELECTRICAL)

IMPORTANT: Read the safety precautions of this booklet carefully before removing the barbecue from

its carton or connecting the barbecue to an electrical supply.

Do not immerse any part of the power pack or cables in water. Do not connect or use the lighting system in the rain.

2. The lighting system should be turned off and disconnected from the main power source whenever it is not in use, or

when changing light globes.

3. Only replace globes with those of equivalent wattage (10W, 12Vac). Using higher rated globes could damage the

globe housing, wiring or power pack. Replacement globes are available from Everdure.

4. All electrical cables should be stowed within the barbecue trolley when the barbecue is not in use.

5. The supply cord plug should be removed from the socket-outlet before any cleaning is done.

6. Do not place cord extension sockets or portable power boards where they may be splashed or where moisture may

get in.

7. Check periodically for damage to the supply cord and power pack. Do not use a damaged appliance and do not

attempt to fix any electrical faults. Contact your Service Centre to have any parts replaced with an equivalent unit.

8. This appliance should be maintained in order to ensure a long, useful life and protect the operator against electric

shocks.

9. A safety switch can enhance electrical safety when using this appliance. If in doubt, speak to a local licensed

tradesperson.

APPLIANCE DETAILS

Gas Type:

Burner Pressure: 2.75 kPa 0.95 kPa Injector Diameter: Ø0.95 mm Ø1.65 mm Heat Input: 70 MJ/ hr 75 MJ/ hr Wok Injector Diameter: Ø0.90 mm Ø1.65 mm Wok Heat Input: 10.5MJ/hr 12.5MJ/hr

Note: The size of the injector diameter is stamped on one of the hexagon faces (e.g. ‘104’ for Ø1.04mm injector).

(Propane and/or Butane gas)

Universal LPG

Natural Gas

Barbecue only 1004 545 220

Grande Esee 1680 640 1220 Barbecue and

Trolley

Secondary Air Inlet (Front) 15mm x full width of fat tray Secondary Air Inlet (Rear) 40 x Ø22mm holes + 60mm x Full width of fat tray

Air is admitted at the underside of the front and rear of the combustion chamber. Exhaust gases are emitted through the grill plate, around the edge of the hot plate and through the louvers in the rear of the hood. The Esee lighting system requires a 240Vac supply (via a standard Australian socket outlet). The supplied power pack is rated to IP64, and supplies 12Vac with a maximum output of 20VA. This transformer complies to Australian Standards AS/NZS 3108 (Safety) and AS/NZS 1044 (EMC).

Grosso Esee 1680 640 1220

LENGTH (mm) WIDTH (mm) HEIGHT (mm)

GAS CONNECTIONS

LOCAL AUTHORITY REQUIREMENTS

Check Gas Type and specifications plate on the left-hand side of the barbecue. All gas fitting work, service and repairs can only be performed by an authorised person in accordance with AS5601 / AG601 and local gas regulations.

NATURAL GAS

Neo 6 burner barbecues can be converted to use natural gas ONLY with a Neo NG 6 burner conversion kit. Fit the NG manifolds, regulator and NG hose. This conversion can ONLY be performed by an authorised person in accordance with AS5601 / AG601 and local gas regulations. Note: The burner pressure (as noted on the appliance details) MUST be checked after installation by turning on and measuring at the regulator output test point. All connections must be checked for leaks.

FOR GAS CYLINDER CONNECTION

1. To achieve the optimum performance from your Barbecue, an approved gas cylinder (POL fitting) of 9kg capacity must be used.

2. Do not connect gas to a barbecue that is not secured in a trolley.

3. Connect the cylinder to the barbecue, via the hose and regulator. Firmly tighten joints, but do not over-tighten. Take

care not to damage the regulator fitting.

LEAK TESTING

1. Make sure gas controls are Off and turn the cylinder valve On.

2. Check for leaking joints by brushing with solution of half-liquid detergent and half water. If a leak is present, bubbles will appear (or you will hear a hissing sound). Retightening connections can generally repair a leaking joint. You must also check the gas hose and connection at the gas cylinder, and at the wok burner. If a leak cannot be resolved, do not proceed.

LEAK TEST ALL CONNECTIONS, INCLUDING THE CONNECTION TO THE GAS CYLINDER. DO NOT USE NAKED FLAME FOR LOCATING GAS LEAKS. IF A LEAK PERSISTS CALL AN AUTHORISED GAS FITTER.

OUTDOOR INSTALLATION GUIDE

This Appliance shall only be used in an above ground open-air situation with natural ventilation, without stagnant areas, where gas leakage and products of combustion are rapidly dispersed by wind and natural convection.

This appliance must not other enclosed areas. The barbecue is not intended to be installed in or used on recreational vehicles (e.g. boats, camping vans) and should not be placed close to or under any surfaces that will burn or are sensitive to heat. Do not block/obstruct the flow of air and combustion around the barbecue housing while in use.

Any enclosure in which the appliance is used shall comply with one of the following:

• An enclosure with walls on all sides, but at least one permanent opening at ground level and no overhead cover.

• Within a partial enclosure that includes an overhead cover and no more than two walls

• Within a partial enclosure that includes an overhead cover and more than two walls, the following shall

apply-

(i) at least 25% of the total wall area is completely open: and (ii) at least 30% of the remaining wall area is open and unrestricted.

In the case of balconies, at least 20% of the total of the side, back and front wall areas shall be and remain open and unrestricted.

be used indoors. Do not use your barbecue in garages, porches, sheds or

+ 11 hidden pages