Euromaid EGE9TS, EGE9TBK User Manual

User Manual

900mm Dual Fuel Upright

Stainless / Black

EGE9TS/EGE9TBK

EG90S 900mm Dual Fuel Upright Page i

Dear Customer:

2

Thank you for choosing our product.

This appliance is easy to use; please read this manual carefully before installing and using the
appliance. The correct indications in the manual are for the best installation, use and care of the
appliance.

You will find that the clean lines and modern look of your oven blends in perfectly with your
kitchen decor. The oven is easy to use and performs to a high standard.

We also make a range of products that will enhance your kitchen - such as cook tops, Range
hoods, built- in hobs, built- in ceramic hobs and built- in ovens. These are models to complement
your new oven.

We make every effort to ensure that our products meet all your requirements. Our customer
relations department is at your disposal to answer all your questions and to listen to all your
suggestions.

Please keep your receipt as proof of purchase.
Also please retain all documents related to the purchase of the product.

Index

3

Caution

Installation instructions:

• Clearances

• Anti Tilt chains

• Gas connection test

Electrical Connection

• Ventilation and gas connection

• Adaptation to different types of gas

• Setting the minimum flame

• Burner and injector characteristic table

Instructions for use

• Description of the main parts of the appliance

• Ignition and operation of the burners

• Recommendations

• Oven function

• Electronic programmer

Instructions for cooking

Page. 4 - 5

Page. 6

Page. 6
Page. 7 - 8
Page. 9

Page. 10

Page. 10
Page. 10
Page. 11

Page.

Page. 12

Page. 12
Page. 13
Page. 13
Page. 14
Page. 15 - 16

Page. 17 - 19

12

Maintenance and cleaning

Warranty

Notes

Page. 19 - 20

Page. 21

Page. 22 - 23

CAUTIONS

4

• This appliance must be installed by an authorised person in accordance with this instruction
manual, AS/NZS 5601.1

• Gas installations (installation and pipe sizing), local gas fitting regulations, local electrical
regulations, Building Code of Australia and any other government authority.

Very important: keep this instruction booklet with the appliance for handy references

• This appliance is designed for use in private home. Please be aware that the front accessory
could be hot to touch.

• This appliance is not intended for use by young children .

• Don't touch the heating elements inside the oven.

• When the grill is on all the accessible elements are hot, hence, keep children away from these

elements.

• This appliance shall be installed only by authorised persons and in accordance with the
manufacturer's installation instructions, local gas fitting regulations, municipal building codes
electrical wiring, regulations,and local water supply regulations.

• Before switching the appliance on check that it is correctly regulated for the type of gas available
(see relevant section).

• Do not use jet of steam for cleaning.

• Before maintenance or cleaning, disconnect the appliance from the mains and wait for it to cool

down. When the burners are lit check that the flame is always regular. Before removing the
saucepans turn the burners off.

• Servicing should be carried out only by authorised personnel.

• The use of a gas appliance produces heat and humidity in the room.

• Make sure that the room is well ventilated, keeping the natural ventilation outlets open or

installing a ventilation hood with rain duct. If a gas appliance is used for a long time it may require
extra ventilation (opening a window or increase the volume of exhaust).

• Never line the oven with aluminum sheets as the slots preset for keeping fast the thermionic
exchange may clog, thus damaging the enamel.

• Be careful not to place saucepans with unstable or deformed bottoms on the burners to avoid
overturning or spilling.

• If the mains of a burner is turned off accidentally, turn off the control knob. Only light the burner
again after waiting at least a minute.

• Before using the oven, we suggest to:

o Remove all the special film covering the oven door glass (when provided)
o Heat the empty oven at max. Temperature for 45 minutes (to remove unpleasant smell

and smoke caused by working residues and by the thermal insulation)

o Carefully clean inside the oven with soapy water and rinse it .

• For any repairs always contact an authorised Technical Customer Service Centre and ask for
original spare parts. Repairs by untrained people can lead to damage.

• Keep packaging out of reach of children at all times.

• Always use oven gloves to remove and replace food in the oven.

• Ensure that you support the grill pan when removing it from the oven.

• Don't let children sit down or play with the oven door.

• Do not use the drop down door as a stool to reach cabinets above.

• Do not remove the plug by pulling the cable.

DO NOT SPRAY AEROSOLS IN THE VICINITY OF THIS APPLIANCE WHILE IT IS IN OPERATION. l
DO NOT STORE OR USE FLAMMABLE LIQUIDS OR ITEMS IN THE VICINITY OF THIS APPLIANCE.
WHERE THIS APPLIANCE IS INSTALLED IN MARINE CRAFT OR IN CARAVANS, IT SHALL NOT BE
USED AS A SPACE HEATER .

WARNING: In order to prevent tipping of the appliance, this stabilizing means must be installed.

5

Refer to the instructions for installation.

During use the appliance becomes hot. Care should be taken to avoid touching heating elements
inside the oven.

WARNING: Accessible parts may become hot during use. Young children should be kept away.

• Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door glass
since they can scratch the surface, which may result in shattering of the glass.

• This appliance is not intended for use by persons (including children) with reduced
physical,sensory or mental capabilities, or lack of experience and knowledge, unless they

have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.

• Children should be supervised to ensure that they do not play with the appliance.

• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or

similarly qualified persons in order to avoid a hazard.

• In the event of burner flames being accidentally extinguished,turn off the burner control and
do not attempt to re-ignite the burner for at least 1 min.

DO NOT MODIFY THIS APPLIANCE
DO NOT PLACE ARTICLES ON OR AGAINST THIS APPLIANCE

Not suitable for use with after-market lids or covers.

This electric appliance complies
with the following directives:

• 89/336/EEC (electromagnetic
compatibility)

• 89/109/EEC (foodstuffs)

• 73/23/EEC + 93/68/EEC (low

voltage)

• 2009/142/EC ( Gas Appliance
Directive)

Warning:

Never use the storage drawer set at the bottom of the range to store flammable substances or matters that
cannot withstand heat such as: Wood, paper, spray cans, rags, etc.

Installation Instructions

6

This appliance is suitable for connection with rigid pipe or flexible hose. The isolating manual shut-off valve connection point
must be accessible when the appliance is installed. Gas inlet is located at the top rear, right OR left hand side, 50mm from the
side edge. Overall dimensions 900mm wide, 600mm deep and 900mm high.

Natural Gas: the supplied regulator must be fitted to the appliance inlet connection. Gas pressure must be adjusted to 1.0 kPa
when approximately 50% of the burners are on high flame, the appliance test point is located on the regulator.

LPG: the supplied test point adaptor must be fitted to the appliance inlet connection. Gas pressure must be adjusted to 2.75
kPa, the appliance test point is located on the test point adaptor. Alternative refer to page 9 for LPG test point.

Suitable for connection with a flexible hose assembly. The flexible hose assembly must be certified to AS/NZS 1869 class B or
D, be of appropriate internal diameter for the total gas consumption, be kept as short as possible (not exceeding 1200mm),
and must not be in contact with the floor or any hot or sharp surfaces. The hose assembly must not be subject to strain,
abrasion, kinking or deformation.

Anti tilt chains are located at the rear of the appliance and must be secured to the wall behind the appliance to prevent
accidental tipping/tilting. The chain length must be as short as practicable to avoid appliance tilting forward and also diagonal
to avoid appliance moving sideways.

NOTE: PLEASE REFER TO PAGES 7 & 8 FOR FURTHER INSTRUCTIONS ON INSTALLTION OF ANTI-TILT CHAINS.

Gas leakage and operation of the appliance must be tested by the installer before leaving. Check all burner flames are blue in
colour, stable and completely ignite at both high and low flame settings with no appreciable yellow tipping, carbon deposition,
lifting, floating, lighting back or objectionable odour. Test burners individually and in combination.

Where the data plate is obscured by cabinetry when the cooker is in the installed position, place the supplied duplicate data
plate to a suitable adjacent surface or within the instruction manual for future reference.

THE MANUFACTURER DECLINES ANY AND ALL RESPONSIBILITIES FOR DAMAGES TO THINGS OR INJURIES TO
PERSONS OR ANIMALS DERIVING FROM INCORRECT INSTALLATION OR USE OF THE EQUIPMENT.

X

X

Hole in cabinet too large,

Allowing the upright oven to tilt

forward

Loose Chain

Incorrect Installation

Accidental Tipping

Figure 1.

Putting the chain into the adjacent cabinet is the preferred method provided

there is no slackness in the chain..

Some installations only have a single chain affixed. Both Chains must be fixed

as part of the installers compliance. Failure to fix both chains will make the

installation non compliant.

X

Chains are provided as a preventative

measure against accidental tipping.

These chains must be fitted as part of

the installers compliance. Failure for

your installer to fit chains in accordance

with the relevant installation code will

make the installation of your upright

cooker non compliant and classed as an

illegal installation.

Incorrect Installation

The photographs on this page are of one

single kind of incorrect installation

(although there are many) which does not

have the chains sufficiently secured, figure

1. shows an example of how far forward an

oven can tip when not secured properly.

Note: Correct installation is part of the

installers compliance.

Left Side of oven, chain

not attached

Chain fixed in two

locations.

Right Side

Correct Chain Installation

Left Side

Once the holes have been drilled the chains can be fed through and the upright can be

fitted into position.

The chains then need to be pulled as tight as possible from inside the cabinet while at

the same time being fixed to the rear of the cabinet using a self drilling wood screw. It is

better to have the screw fixed closer to the hole for better support. The left and right

side examples shown have two extra screws attached to the chain which makes the

installation neater by keeping the chain off the shelf away from the gas and electricity

supply, they will also provide added support.

At this point the oven will be secured in location and will not move forward at all, It is

recommended that all upright oven chains be fitted in this way.

Installation forms part of the installers compliance and that are in line with

regulations. Chains are designed to be installed to prevent cooker from tilting.

In order to prevent the oven from tipping forward as shown on the previous page, we need

to make sure both chains provided with the oven are used.

On the left side of the oven a 16mm drill bit was used to drill through the cabinetry into the

adjacent cabinet, as you can see the hole has not been drilled hard up against the wall

because there is a 16mm board at the rear of the cabinet. The height of the hole from the

floor is level with where the chain attaches to the oven.

The right side has been drilled much the same,, a new hole has been drilled below

the gas and power supply hole.

Hole and

Chain Level.

Chain fixed in

two locations

They are not designed to replace parental supervision when the cooker is in use.