Euro Appliances ESPYM60TSX Instructions For Installation And Use Manual

*%
Instructions for installation and use
)
Instructions pour l’installation et l’utilisation
,
Istruzioni per l’installazione e l’uso
(6
'(
Installation und gebrauch
37
Instruções de instalação e utilização
1/
Installatie-en gebruikshandleiding
Electronic ovens
Four électroniques
Forno Elettronico
Electrónica horno
Elektronische Öfen
Electrónicas forno
Elektronische Oven
*%
1
TABLE OF CONTENTS
SAFETY INSTRUCTIONS............................................................................... 2
INSTALLATION OF THE OVEN...................................................................... 3
Electricals........................................................................................................ 3
Connection to the electrical power mains........................................................ 5
INSTRUCTIONS FOR USE............................................................................. 6
Oven Racks..................................................................................................... 6
Oven extendable racks (if present).................................................................. 7
Cooking functions............................................................................................ 8
Electronic control............................................................................................. 10
DOOR LOCKING SYSTEM............................................................................. 17
Automatic door locking during pyrolytic cycle.................................................. 17
Oven lights....................................................................................................... 17
CLEANING AND MAINTENANCE................................................................... 18
Self-cleaning cycle (pyrolytic cycles)............................................................... 18
Oven door removal.......................................................................................... 19
Replacement of the oven light......................................................................... 20
GUIDANCE TEMPERATURE AN TIME SCHEDULE FOR COOKING........... 21
At the end of the product life cycle, the products equipped with electronics, which have not gone through a selection process, are potentially dangerous for the environment and for human health due to the presence of dangerous materials. This appliance cannot be thrown in the domestic waste at the end of its life cycle. Therefore it must be delivered to an authorised waste collecting center tomake it safe and to recycle its parts in order to respect the environment.
*%
2
SAFETY INSTRUCTIONS
- Do not disassemble any parts prior to having disconnected the oven from the mains.
- Do not use the appliance if any part is broken (for example a glass).
Disconnect it from the mains and call service.
- Before using the oven, it is recommended to make it operate at noload at the maximum temperature for an hour to eliminate the insulating material odour.
- In all models, leave the door closed when the grill is used.
- The cooling fan may remain in operation so long as the oven is hot, even after it has been switched off.
- During the use the appliance becomes very hot; don’t touch the heating elements inside the oven.
- During the oven operation, the front is heated as well; consequently keep children clear of the oven, specially during self-cleaning.
- Parents and adults should pay particular attention when using the product in presence of children.
- Children should be overseen so as to ensure that they don’t play with the equipment.
- This appliance is not intended for use by persons (included children) with reduced physical sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsable for their safety.
- In order to avoid damage to the oven enamel coat, do not cover the oven mufe sole with any item (e.g. aluminum foil, pans and the likes).
*%
3
INSTALLATION OF THE OVEN
To install the oven into the kitchen a cutout should be made in accordance with the dimensions shown in Fig. 1. The apparatus is to be fastened to the top by means of the two screws provided in the kit through the holes made on the oven uprights. The cabinet in which the apparatus is installed shall be open on the back side to ensure a sufcient air circulation and prevent overheating. Leave a gap of at least 200 cm2 (see Fig. 1) for air circulation if the oven is installed in a column; this is not necessary if the oven is installed under the work top.
WARNING As the apparatus is to be tted in your kitchen furniture, make sure that all surfaces in contact with the oven can resist a temperature of approx 90°C.
Electricals
- Absorbed power:
oven top element:................................................................... 2000+1000 W
oven bottom element: ............................................................ 1200+400 W
round element (hot air): ......................................................... 2300 W (on some models)
roasting jack motor: ............................................................... 4 W (on some models)
lamp: ....................................................................................... 25 W
hot air fan motor:...................................................................... 25 W
cooling fan motor:..................................................................... 25 W
- Maximum absorbed power: (see data plate).
- Supply voltage: (see data plate).
NOTE
This appliance is in compliance with following European directives: 2006/95/CE (LVD), 2004/108/CE (EMC), 2002/95/CE (RoHS), 2002/96/CE (WEEE), 2002/40/CE.
*%
4
H
Appliances ABCDEFGH Single oven
56 55 58,5 59,5
Min
1,3
58,9 59,5 86,5
Dimensions are in centimeters
Fig. 1
*%
5
Connection to the electrical power mains
WARNING
This apparatus must be earthed.
The oven is only for domestic use. The feed voltage and the absorbed power are as indicated on the data plate attached to the left-hand side upright, which can be seen when the oven door is open. Connecting must be carried out by qualied personnel and in accordance with the regulations currently in force.
The manufacturer can not be held responsible for any damages to persons or objects caused by failure to observe these instructions.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualied persons in order to avoid a hazard.
The oven must be connected to the mains through a multipole circuit breaker with a contact-to-contact gap of at least 3 mm, making sure that the earth wire is not disconnected. For connecting use a exible cable of the H05V2V2-F 3x1,5 mm
2
type
remembering to make it long enough to allow the oven to be removed from its housing unit when maintenance work is required.
To connect the cable to the oven proceed as follows (see Fig. 2):
- Remove the lid (1) by unfastening the three screws (2). Unfasten the two screws (3) for the cable holder and feed the cable through the opening immediately below the cover.
- Remove about 12 cm of the outside insulation from the cable and shorten the two active wires (live and neutral) to 6 cm, leaving long the one to be connected to the main earth terminal on the terminal box; remove about 1 cm of the main insulation from the three wires and connect them correctly to the terminal box, remembering to respect the polarities.
- Tighten the two screws (3) of the cable holder and put the lid (1) back on with the three screws (2).
Fig. 2
*%
6
INSTRUCTIONS FOR USE
Oven Racks
WARNING Never use aluminum foil to cover the oven racks or to line the oven. It can cause damage to the oven liner if heat is trapped under the foil.
WARNING
Make sure you do not force it to avoid damage to the enamel.
The oven has rack guides at four levels. Rack positions are numbered from the bottom rack guide (#1) to the top (#4). Check cooking charts for best rack positions to use when cooking. Each level guide consists of paired supports formed in the walls on each side of the oven cavity. Always be sure to position the oven racks before turning on the oven. Make sure that the racks are level once they are in position. The racks are designed to stop when pulled forward to their limit.
T o remove o ven rac k from the o ven (see Fig. 4):
1 Pull rack forward. 2 Lift rack up at front and then remove it.
To replace an oven rack (see Fig. 5):
1 Place rear of rack between rack level
guides.
2 While lifting front of rack, slide rack in all
the way while lowering the front.
1
2
1
2
Fig. 4
Fig. 5
Fig. 3
Loading...
+ 16 hidden pages