Euro Appliances ERB120SS User Manual

ERB120SS

CONTENT

2……………………………………….Notice

3………………………………………..Installation

5………………………………………..Notice of installation

6…………………………………………Use

7………………………………………..Safety Warning

8…………………………………………Maintenance

10…………………………………………Abnormity and Solution

1

NOTICE

1. Thank you for choosing our cooker hood. Please read the

instruction manual carefully before use.

2. The installation work must be undertaken by a qualified and

competent fitter.

3. The manufacturer disclaims all liability for any damage or

injury caused as a result of not following instructions for
installation contained in the following text.

The cooker hood is used on 220/240v, 50Hz.

Contents

1X Rangehood
1X Packet of Screws
1 X Operating Instructions

2

(1) INSTALLATION

1. The cooker hood should be placed at a distance of 65­75cm (26-30inch) from the cooking surface for the best
effect.

2. After deciding the installation height of the hood, drill
6 x Φ8 holes according to pic 2.

3. Put the plugs into the 2 bracket holes and 2 safety
holes, and put the M6*60 explosive bolt into the 2 key holes. Fix the
inside chimney bracket onto the wall with 2 ST4 x 40 screws. See pic 3.

4. Take off the 8 filters according to 1-2-3 step. See pic 4.

5. Hang the hood on the two explosive bolts and lock nut. See Pic 5

6. Screw 2 ST4 x 30 through the back of the hood. See pic 6.

7. Fasten the extension pipe onto the outlet with a tie. See pic 7

8. Put the inside chimney inside the outside chimney. Take them together
and put them on the top of the hood. Then pull the extension pipe, and
fasten the other end to the wall. See pic 8.

9. Pull the inside chimney upwards, then connect the inside chimney to
the inside chimney bracket with 2 ST 4 x 8 screws. See pic 9.

Explain the instructions:

a. Connection of the appliance to the supply mains.
b. Necessity to allow disconnection of the appliance from the supply

after installation. Disconnection may be achieved by having the
plug accessible or by incorporating a switch in the fixed wiring in
accordance with the wiring rules.

Warning: Failure to install the screws or fixing device in accordance

with these instructions may result in electrical hazards.

3