ETS PM1-LE, PM1-SS-LN Specsheet

PM1-x Microphone Instructions

The PM1- x is a high quality, 12 to 48VDC phantom powered, balanced output, un- pre-amplified microphone for use with
professional audio consoles or security equipment with compatible microphone inputs .

PM1-x Microphone Placement.

Locate the PM1-x Microphone near the area of interest in the room to be monitored. If the entire room is to be monitored,
locate the PM1-x in the middle of the room. Do not mount the microphone near air conditioning vents, light fixtures or
electrical equipment. The PM1-x should be placed as close as possible to the subject(s) to be monitored. The PM1-x is
still useable in the range of 10-25 feet but is dependent on the level of background noise in the area. Experimentation in
the environment will determine what distances work best. In outdoor applications, it is best to locate the microphone
where it is not directly exposed to the elements to avoid accumulation of water, snow or ice. The PM1-WPW can
withstand extreme weather but the collection tube may still become blocked as a result of direct exposure to precipitation.
PM1-W and PM1-WPW have removable windscreens for cleaning purpo ses.

Cable Run

Run a 22 gauge, stranded, two conductor, shielded cable between the PM-1 microphone and the monitoring device or
mixing console. Keep the cable run distance under 500 feet and away from AC power sources, light fixtures and electrical
equipment. Connect the PM1- to a mixing console or other equipment as shown in the diagram below.

Caution

It may be against the law to install this microphone kit in certain environments. It may also be against the law to record conversations of
the person(s) being monitored without their knowledge. It is the responsibility of the installation company and end-user to det ermine if
the application of this product is legal. These laws vary from state to state. If you are not informed on these matters, consult a qualified
attorney or contact the appropriate state agency. A sticker is provided with this kit for the applications where notification must be
posted.

Warranty

All ETS products carry a one year parts and labor warranty. This warranty does not cover damages as a result of misuse, improper
handling of the unit or exposure to extreme temperatures or moisture. At its discretion, ETS reserves the right to repair or replace this
unit under the conditions of the warranty. If you experience problems with your equipment call ETS at: 505-888-3923 to obtain a return
authorization number. Equipment requiring repair beyond the warranty period or units that have been damaged or are not covered
under the warranty can be repaired by ETS for a minimal cost under most conditions.

Made in the USA

by