ETC Source Four PAR XWFL Lens Kit Assembly Guide

ETC® Assembly Guide

PAR XWFL Lens Kit

Overview

When the XWFL lens (PN 7061A1042) is used in a Source Four PAR, the lens must be equipped with
four Tinnerman clips (PN HW8203), which are installed at the factory. The clips do not interfere with the
light beam.

If the clips are removed, follow the i llustration below to reinstall them.

.

WARNING The XWFL lens is approximately 3.2mm (1/8 inch) smaller in diameter than the

NSP-WFL lenses shipped with the EA and MCM PARs. The clips provided with
the XWFL lens must be used to secure it safely in the lens ring.
Failure to observe

this warning could result in serious injury.

Note:

The clips must be installed 90° apart and so that every other one is facing the back
of the lens.

Facing

back

1

Facing

front

Facing

front

1.6mm
(1/16")

Corpor ate Headquarters
London, UK
Rome, IT
Holzkirc hen, DE
Hong Kon g
Service:
Web:

www.etcconnect.com

7061M1017

Facing

back

2

Unit 26-28, Victoria Industrial Estate, Victoria Road, London W3 6UU, U K Tel [phone] Fa x [phone]

Via Ennio Quirino Visconti, 11, 00193 Rome, Italy Tel [phone] Fax [phone]

Rm 1 801, 18/F, Tower 1 Ph ase 1, En terprise Square, 9 Sheung Yuet R oad, Kowloon Ba y, Kowloon, Hong Kong Tel + 852 2799 1220 F ax [phone]

(Americas) ser [e-mail] (UK) [e-mail] (DE) techserv-hoki@e tcetcconnect.co m.com (Asia) [e-mail]

Rev C Releas ed 10/ 2007

3031 Pleasant View Road , P.O. Bo x 620979, Midd leton, Wisconsin 53562-0979 USA Tel [phone] Fax [phone]

Ohmstrasse 3, 83607 Holzkirchen, Ger many Tel [phone] Fax [phone]

Copyright © 2007 ETC. All Rights Reserve d. Product inform ation and specifi cations subject to change.



ETC intends this d ocument to be provided in its e ntirety.

.cnI ,slortnoC ertaehT cinortcelE1 fo 1 egaPediuG ylbmessA tiK sneL LFWX RAP