essential W1700-14 User Manual

ITEM #W1700-14

Made in China

2014 ESSENTIAL MEDICAL SUPPLY, INC.

®

Manufactured for

Orlando, FL 32822

with Loop Hand Brakes

Page 1

-- SAVE THESE INSTRUCTIONS --

SET UP INSTRUCTIONS

1. Remove all contents from carton and remove protective packaging.
The carton should contain the following:

Do not attempt to adjust or operate your Essential Rollator walker
without carefully reading all instructions in this manual. If, after reading
this manual, you have any questions, please call your health professional
or place of purchase, otherwise injury or damage may occur.

Tote

Height Adjustment
Knobs (2) with Bolt

& Washer

Hinged Folding

Mechanism

Loop Brake Handles

are attached to the

Frame by Cables (2)

Backrest

Bracket

Serial No. Label

on back

(White label, number

starts with “CB-”)

Backrest

Do not use the walker if there is apparent
damage and/or if parts are missing.

Please call place of purchase for
repair/return information.

Page 2

2. To open the frame, push down on the hinged folding mechanism
until it is straight.

SET UP INSTRUCTIONS

3. Install the backrest and handles.

(a) To insert the backrest, push in the knobs on the outside of the

backrest and insert the backrest into the brackets on the front
of the walker frame. If properly installed, the backrest should
click into place and the pins should protrude into the holes.

(b) Unscrew height adjustment knobs from handles and insert

handles into the frame of the walker while making sure the
cables are on the outside of the frame.

(c) Adjust the handle height as directed by your physician,

physical therapist or trained professional. Insert the bolt from
inside of the frame so that the hex head ts snugly into the six
sided hole in the frame.

(d) On the outside of the frame, place the washer on the bolt and

rotate the knob clockwise until fully tightened. Make sure that
the bolt head is still securely recessed in the frame.

Tote

Height Adjustment
Knobs (2) with Bolt

& Washer

Hinged Folding

Mechanism

Loop Brake

Handles are

attached to

the Frame by

Cables (2)

Backrest

Backrest

Bracket

Serial No. Label

on back

4. Make sure all attached hardware is tightened securely.