ESI ALL-FLEX FLEX3-SLV-V1, ALL-FLEX FLEX3-BLK-V1, ALL-FLEX FLEX3-WHT-V1 Assembly And Operation Manual

ASSEMBLY AND OPERATION

ALL-FLEX

3 LEG ELECTRIC TABLE BASE

FLEX3-V1 Rev B 6/17

™

Model FLEX3-SLV-V1
Model FLEX3-BLK-V1

Model FLEX3-WHT-V1

ALL-FLEX™ 3 LEG ELECTRIC TABLE BASE PARTS AND TOOLS

Work

Surface

PLEASE REVIEW these instructions before beginning the assembly procedures. Check that all the parts shown
below were provided with your order. Contact your supplier if any materials are missing. Do not discard the

your satisfaction.

PARTS AND TOOLS PROVIDED

Leg Hinged to Frame (2)

Center Leg (1)

Adjustable Feet (2)

Fasteners

Left

Right

Cross Channel (2)Side Leg Top Support (2) Control Unit Bracket (1)

Digital Keypad (1)Control Unit (1) Cable Clip (4)Power Cable (1)

Allen Keys (1 each))

Center Leg Top Support (2)

Right

Left

M6x15 (14)M10x45 (8)

NOTE: This install requires a power tool or
cordless drill. Except for the hex head
screws, which is not a hand tool install.

ADDITIONAL TOOLS REQUIRED

•

#2 Phillips drill bit

• Power Driver

2

M5x18 (18) M4x23 (2)

CAUTION: Always check that screws used to
attach components to the work surface are
not too long for the thickness of the surface.

3mm 5mm4mm

ASSEMBLY ALL-FLEX™ 3 LEG ELECTRIC TABLE BASE

STEP 1

With the work surface facing down on a soft, clean surface, arrange the leg columns and center leg top
supports as shown.

• Unfold the hinged side legs and place them motor-side down at the ends of the work surface.

• Place the center leg motor side down near the 90° or 120° angle of the table.

• The mounting tabs on the leg columns and top supports must be face down so that they are against the
work surface.

Leg Column

with Frame

(Right)

Mounting Tabs

Center Leg

Top Support

(Right)

Center Leg

Center Leg

Top Support

(Left)

Leg Column

with Frame

(Left)

STEP 2

Lock the side leg columns in the upright position.

• Use the 4mm Allen key to install M6x15 hex head
screws into the frame and motor.

M6x15

4mm

Allen Key

3

ALL-FLEX™ 3 LEG ELECTRIC TABLE BASE ASSEMBLY

90°

120°

STEP 3

Route the side column motor cables under the notch on the angled
portion of each frame.

Route Cable

STEP 4

Install the cross channels.

• Insert each cross channel into the frame and center leg top support.

—

• Slide the top supports under the center leg brackets. Align the holes on the top supports with the 90° or
120° holes in the brackets. See the illustration below.

• Position each cross channel so that its center line is centered between the frame and the top support.

• The MAX lines must not extend beyond the frame and top support.

Under Notch

Cross Channel

MAX

Frame Top Support

Rear

Center Line

MAX

Set Screws

Cross Channel

STEP 5

Attach the top supports to the center leg brackets.

• Use the 4mm Allen key and four M6x15 hex head
screws.

• Use the inner hole on the bracket for 90° tables
and the outer hole for 120° tables.

Center Leg

Bracket

Top Support

4mm
Allen

Key

4

M6x15

Top

Support