Escort Solo S3 Owner's Manual

O w n e r ’ s M a n u a l

R A D A R•L A S E R•S A F E T Y•D E T E C T O R

Radar Antenna and Laser Lens

The rear panel of your Solo S3 should have a clear
view of the road ahead. For best performance,
do not mount Solo S3 directly behind
windshield wipers or tinted areas.

Graphic OLED Display

During an alert, the display will turn on and
indicate radar band, and a precise bar-graph of
signal strength. Programming options and SWS
messages are also displayed.

NOTE: When using Solo S3 in battery mode, the
display will turn off automatically until a signal is
detected, or you enter program mode. This maximizes
battery life. When using the optional 12-volt
SmartCord, the display will remain on and provide
several pilot options for power-on indication.

To begin using the Solo S3, just follow these simple
steps:

1 Install (2) AA batteries (included) in the battery
compartment. (Please note polarity)

2 Mount your Solo S3 on the windshield using the
supplied windshield mount.

3 Press the Power button (PWR) located on the left

side of the front panel.

4 Adjust the volume (VOL) by pressing the up and

down buttons located to the right of the display.

Please read the manual to fully understand Solo
S3’s operation and features.

Quick Reference Guide

1

2-volt Power Jack

For 12-volt operation, plug the optional SmartCord

into this connector.

Mute / Battery Status Button

Briefly press this button (located on top) to silence
the audio for a specific alert.

Ear Phone Jack

A standard 1/8 inch (or 3.5 mm) earphone jack is

located on the right front side of the Solo S3.

Mode Button

Switches sensitivity between Highway,
AutoSensitivity, and City settings. In general, we
recommend the AutoSensitivity mode.

Volume Control

Press the up or down button to adjust the S3’s
volume.

EZ-Programming

Solo S3 is ready to go, just plug it in and turn it on. If

you prefer, you can also easily customize up to

9 fea-

tures for your specific driving preferences.

AutoMute

Solo S3’s patented AutoMute automatically reduces

the volume level of the audio alert after a brief period.

If you prefer, you can turn AutoMute off.

EasyMount Slot

Insert Solo S3’s adjustable Windshield mount into

this slot.

EasyRelease Button

Press the release button, and slide the Windshield

mount into one of its four locking positions.

Rear Laser Port

Receives laser signals from behind the vehicle.

Power-On Indication

Three LED's (green, yellow, red) mounted between

the PWR button and the display, indicate power

(blinking in battery mode, solid when optional 12-

volt power cord is used). These also indicate the

sensitivity mode that the unit is in,( "H" for highway,

"A" for AutoSensitivity, and "C" for city).

Power

Press the PWR button to turn Solo S3 on. Press and

hold the PWR button to turn Solo S3 off.

AutoPwr Feature

The Solo S3 will automatically shut off once the

vehicle has stopped moving for approximately 25

minutes.