Escalade sports P2015 User Manual

OWNER’S MANUAL

ATLAS 7 FT. DROP POCKET POOL TABLE

MODEL NO. P2015

1. READ THIS MANUAL CAREFULLY BEFORE STARTING ASSEMBLY.
Read each step completely before beginning each step.

2. SOME SMALLER PARTS MAY BE SHIPPED INSIDE LARGER PARTS. CHECK INSIDE ALL PARTS
AND CARTONS BEFORE ASSEMBLING OR ORDERING PARTS.

3. USE THE HARDWARE IDENTIFIER TO IDENTIFY AND SORT ALL FASTENERS.

PLEASE DO NOT RETURN PRODUCT TO THE STORE!

Contact Escalade® Sports customer service department at:

Phone: [phone] Toll Free !

Fax: [phone] Toll Free !

E-mail: [e-mail]

Mailing Address: Escalade® Sports, PO Box 889, Evansville, IN 47706

Please visit our World Wide Web site at:

www.escaladesports.com

On-Line Trouble Shooting Frequently Asked Questions

Technical Assistance On-Line Parts Requests

Additional Escalade® Sports Product Information

2L-6757-00

Escalade® Sports products may be manufactured and/or licensed under the following patents.
D446275
Additional patents may be pending. One or more of the listed patents and/or pending patents may cover specific product.

CAUTION

To ensure safety, do not attempt to assemble system without following instruc­tions carefully. Proper and complete assembly, use, and supervision is essential for
proper operation and to reduce the risk of accident or injury. A high prob­ability of serious injury exists if this system is not installed, maintained, and
operate properly.

Tools Needed: (Not Included)

• Phillips Screwdriver

NOTE: Rails are made with cushion rubber at a height that requires standard 2 1/4” diameter balls.
Your dealer has a complete line Billiard Accessories.

NOTE: This table adds weight to any floor. Be sure floor can withstand this kind of weight. If floor sags,
table will be impossible to level.

Page

• 3/8” Open End Wrench

2

FLIPPING TABLE REQUIRES AT LEAST THREE CAPABLE
ADULTS.

Set up instructions:

DO NOT LEAVE TABLE STANDING ON WHEELS
UNATTENDED.

1. Flip table over and lay on broken down shipping carton.

2. Remove bolts (#33) and wing nuts (#37) securing leg straps to

beams and fold legs up.

3. Select height for table, see Detail A, and secure leg straps to beam

using bolts (#33) and wing Nuts (#37) removed in step 2.

4. Attach two wheels (#27 ) closest to

playbed using four screws (#28)
for each wheel. See Detail B.

5. Attach other two wheels (#27 ) using four bolts (#29), four washers

(#30) and four nuts (#31) for each wheel. See Detail B.

6. Flip table over onto legs. (See Caution)

7. Using a carpenter's level determine the highest corner of the frame.

Raise other three corners to the level of the highest corner by
adjusting the swivel feet (#41).

Detail A

Detail B

INDIVIDUAL LOCATION SHIMMING

Individual location shimming can be done, IF NECESSARY, by following the following steps.

A) Be sure table is set in its final location.
B) Table must be as level as possible before shimming. Large differences in levelness must be

corrected by raising or lowering frame with shim stock.

DO NOT ASSUME FLOOR IS LEVEL!

C) Check with a carpenter's level to determine where bed is low. Loosen screws from underneath,

at these points and see if slatron comes up to flat. If so, detach individual shims #44
from the sheet shipped with this table and place under these areas. Place shims next

to screws.

D) Lay a straight edge across bed to be sure it is flat.

Page

3