Escalade sports B2412 User Manual

MODEL NO.

B2B2

B2

B2B2

412412

412

412412

Goalrilla
Hooplight

OWNER'S MANUAL

1. Read this manual carefully before starting assembly. Read each step completely before beginning

each step.

2. Some smaller parts may be shipped inside larger parts. Check inside all parts and cartons
before assembling or ordering parts.

3. To make assembly of your basketball system easier, use the Hardware Identifier on page 3
and 4 to identify and sort all fasteners. Check all cartons for kits. All hardware is not located
in one kit.

4. Do not tighten hardware until instructed to do so. If hardware is tightened too soon, mounting holes

may not align and parts may not easily fit together. Leave locknuts slightly loose until you are instructed to
tighten them.

Please Do Not Return This Product To The Store!

Contact Escalade® Sports customer service department at:
Phone: 1-888-USA-GOAL Toll – Free !
Fax: [phone] Toll – Free !
E-mail: [e-mail]
Mailing Address (correspondence only):
Escalade Sports
PO Box 889
Evansville, IN 47706

Please visit our World Wide Web site at: www.escaladesports.com

ON-LINE TROUBLE SHOOTING TECHNICAL ASSISTANCE

ON-LINE PARTS REQUESTS FREQUENTLY ASKED QUESTIONS

ADDITIONAL ESCALADE® SPORTS PRODUCT INFORMATION

2L-6798-01

Escalade® Sports products may be manufactured and/or licensed under the following patents.
6419596, 6179733, 5919102, 5071120, 4798381, 4424968, D326128
Additional patents may be pending. One or more of the listed patents and/or pending patents may cover specific product.

Figure 1

3. Identify Pole Sections "A" through "D" by their labels.

Note: This unit is equipped with U-Bolts to fit GoalrillaTM and
GoaliathTM basketball units with 4 x 4, 5 x 5, 6 x 6, and 6 x 8
poles. Select the U-Bolt by measuring your pole and referring to
the "Hardware Identifier" in this manual.

1. Attach a Black Bracket (#17) to pole 3" below top pivot point, as

shown in Figure 1, using a U-Bolt (#18), two washers (#15) and two
hex nuts (#16).

2. Attach a second Black Bracket (#17) 13" from top pivot point, as

shown in figure 1, using a U-Bolt (#18), two washers (#15) and two
hex nuts (#16).

4. Hold Pole Section "D" (#11) next to the Black Brackets (#17) with

1" of pole below the bottom Black Bracket (#17). Place a U-Bolt
(#14) around the Pole Section "D" (#11) and into the small slots
of the Black Bracket (#17). Secure using the two flat washers
(#15) and hex nuts (#16). See Figure 2. Note: Do not over

tighten as there may be some adjusting required.

5. Repeat the last step with the other Black Bracket (#17) and U-

Bolt (#14).

6. Remove the wing nut, lock washer and screw at top of light that holds

Figure 3

Figure 2

frame together. The door frame assembly will swing down to open.
Using gloves or soft cloth insert one end of bulb into socket specified
on light. Gently apply pressure to the bulb and insert opposite end of
bulb into other socket. Close door and secure with screw, lock washer
and wing nut. Repeat for other light unit. Note: Do not touch

halogen bulb with your hand as oil in your skin will cause
damage to the bulb. Reverse this procedure to remove the
bulb.

3