Ernie Ball Ambient Delay User Manual

EXPRESSION CONTROL

Rock foot back and forth to adjust desired
amount of digital delay and reverb mixed
with original signal.The trimpot located
on the underside of the pedal adjusts the
maximum amount of effect signal in the toe
down position.

HEEL DOWN — buffered original signal, no effect.

CONTROLS PANEL

CONTROLS

REVERB knob will adjust the desired amount

of plate reverb mixed into the original signal
and delay repeats.

FEEDBACK knob will adjust the desired

number of delay repeats.

TIME knob will adjust the desired length of

time between delay repeats. The TIME knob
and the TAP TEMPO footswitch control the
same parameter, and adjusting either one
overrides the other.

I/O

INPUT connects to instrument with 1/4” mono

TOE DOWN — delay level at maximum (at most

equal to the original signal level). Reverb level at
maximum as set by the REVERB knob. Original
dry signal level remains the same (unity gain).

LIMITED WARRANTY

Ernie Ball, Inc. will guarantee your Ernie Ball pedal for 6 months from the date of original purchase against defects in workmanship and materials. If a defect arises, the pedal will

be repaired without charge if delivered FREIGHT PREPAID to the following address. It will be returned to you freight prepaid when repair is complete. It is not necessary to mail a

warranty card to us; however, claim must be accompanied by PROOF OF PURCHASE in the form of a legible photocopy of your original sales slip showing where you bought it.

WE WILL NOT WARRANT YOUR E.B. PEDAL IF: Alterations, modifications, or add-ons have been made. Unauthorized repairs have been performed or attempted. Damage is

caused by mistreatment or accident. United Parcel Service is recommended for shipping returns. ERNIE BALL INC./Pedal Rebuilds 53-973 Polk St. Coachella, CA 92236

Check out the FAQ section at http://www.ernieball.com/faq or call us at 1 [phone]

subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

FOR MORE INFORMATION ON PEDAL REBUILDS

This device complies with part 15 of the FCC Rules. Operation is

instrument cable (Input impedance 1MΩ).

9V connects to a power adapter via the standard

5.5/2.1mm DC jack (center pin negative; 135mA
current consumption).

OUTPUT connects to amplifier with 1/4” mono

instrument cable (Output impedance <10KΩ).

TAP TEMPO connects to a momentary normally

open footswitch with a 1/4” mono instrument
cable. Press and release the TAP TEMPO switch
rhythmically to set desired delay time
(Alternative to using the TIME knob).

V1 09/01/16