Built with Anthro-DNA™
Zido® 8" Handle
User's Guide
Product Part#
Zido Handle 8" ZHHSB
NOTE: Shown on a Zido Pole Cart, sold separately.
For the latest User Installation Guide please visit: www.ergotron.com
300-5472-00 rev. B • 06/16
1 of 4
03
06
07
02
08
01
05
TOOLS
A 1/8" Hex Key is provided for
this assembly. You'll also use the
5/32" hex Anthro driver which
came with your Zido cart.
A 3/8" socket, nut driver, or
wrench is required but not provided.
PARTS LIST
Before beginning assembly of your Zido 8" Handle,
please review the parts list to verify that your shipment is
complete.
The fastener quantities listed here are the minimum required for your assembly. You may receive a few extras.
Product Quantity Part Number
01 Zido 8" Handle Bracket 1 225-2986-00
02 Zido 8" Handle Support 1 225-2985-00
03 Zido 8" Handle Tube 1 125-5337-00
04 Zido 8" Handle Wrap 1 175-5275-00
(Not shown; installed on the tube at the factory.)
05 1/2" Self-threading Screws 3 325-5464-00
06 1/2" Flat-head Screws 4 325-5193-00
07 2" Button-head Screws 2 325-5034-00
08 10-24 Nylock Nut 4 325-5186-00
09 1/8" Hex Key 1 375-5015-00
(Not shown.)
2 of 4
300-5472-00 rev. B • 06/16
STEP 1
Install the Handle Bracket
Select the installation point for the
handle.
Align the handle Bracket with the
holes on the column or Extension
Tube.
Install the Handle Bracket with three
1/2" Self-threading Screws.
Self-threading Screw
325-5464-00
STEP 2
Install the Handle Support
Align the Handle Support with the
Handle Bracket so that the curved side
is on the bottom and the at side is on
top.
Feed one 1/2" Button-head Screw
through the Handle Support and the
Handle Bracket and loosely capture
with a Nylock Nut. Repeat for the
remaining three screws and nuts,
then tighten. Use the provided 1/8"
Hex Key and your own 3/8" socket,
nut driver, or wrench to tighten the
fastener.
1/2” Flat-head Screw
325-5193-00
STEP 3
Install the Handle Tube
Align the Handle Tube with the holes
on the support.
Using the 5/32" hex Anthro driver (it
came with your cart), loosely attach
with two 2" button-head screws.
Nylock Nuts
325-5186-00
Tighten all the screws on the support,
the bracket, and then on the tube.
2” Button-head Screw
325-5034-00
300-5472-00 rev. B • 06/16
3 of 4
For Warranty visit: www.ergotron.com/warranty
For Service visit: www.ergotron.com
For local customer care phone numbers visit: http://contact.ergotron.com
© 2016 Ergotron, Inc. All rights reserved.
All trademarks are the property of their respective companies. Anthro is a registered trademark and brand of Ergotron Inc.
Anthro-DNA is a trademark of Ergotron Inc.
4 of 4
300-5472-00 rev. B • 06/16
Loading...