Features & Specifi cations
15” (381 mm)
User's Guide
WorkFit-T
Sit-Stand Desktop Workstation
Components
1
> 24”
(61 cm)
ABCD
> 35” (89 cm)
A
B
A+B=
10 - 35 lbs
(4.5 - 15.88 kg)
< 5 lbs
(2.27 kg)
10 - 35 lbs (4.5-15.9 kg)
< 18”
(45.7 cm)
24.8”
(63 cm)
CAUTION: DO NOT EXCEED
MAXIMUM LISTED WEIGHT
CAPACITY. SERIOUS INJURY
OR PROPERTY DAMAGE MAY
OCCUR!
ENGLISH
For the latest User Installation Guide please visit: www.ergotron.com
User's Guide - English
Guía del usuario - Español
Manuel de l’utilisateur - Français
Gebruikersgids - Deutsch
Benutzerhandbuch - Nederlands
Guida per l’utente - Italiano
Användarhandbok - svenska
ユーザーガイド:日本語
用户指南 : 汉语
888-33-373-G-00 rev. C • 11/14
Includes
Constant Force™
Technology
1 of 6
Safety
Warning: Because mounting surface materials can vary widely, it is imperative that you make sure mounting surface is strong
enough to handle mounted product and equipment.
WARNING
DO NOT place hands on or near support bars. Pinch points are
PINCH POINT
created during lifting and lowering the worksurface. Failure to
follow these instructions may result in serious personal injury.
ENGLISH
828-100
Warning: Impact Hazard! Moving Parts can Crush and Cut.
Raise worksurface to top of vertical adjustment BEFORE removing equipment.
Failure to heed this warning may result in serious personal injury and or property damage!
Caution:
To avoid the potential to pinch cables it is important to follow the cable routing instructions
in this manual. Failure to follow these instructions may result in equipment damage or
personal injury.
Caution:
Leave enough slack in cable to allow for full range of vertical motion (15” / 38 cm). Failure to
heed this warning may result in property damage and or personal injury.
Caution:
Keep monitor and laptop base fully on the worksurface. Allowing any part of base or stand to
hang o the edge may result in property damage and or personal injury.
Caution:
Raise worksurface slowly. Raising worksurface too fast may create an unstable situation
resulting in property damage and or personal injury.
2 of 6
888-33-373-G-00 rev. C • 11/14
1
2
3
ENGLISH
888-33-373-G-00 rev. C • 11/14
Caution:
Keep monitor and laptop base fully on the worksurface. Allowing any part of base or stand to
hang o the edge may result in property damage and or personal injury.
3 of 6
4
5
ENGLISH
Caution:
To avoid the potential to pinch cables it is important to follow the cable routing
instructions in this manual. Failure to follow these instructions may result in
equipment damage or personal injury.
4 of 6
888-33-373-G-00 rev. C • 11/14
6
Caution:
Leave enough slack in cable to allow for full range of vertical motion (15” / 38 cm). Failure to
heed this warning may result in property damage and or personal injury.
ENGLISH
888-33-373-G-00 rev. C • 11/14
5 of 6
Set Your Workstation to Work For YOU!
Learn more about ergonomic computer use at:
www.computingcomfort.org
Height Position top of screen slightly below eye level.
Position keyboard at about elbow height with wrists fl at.
Distance Position screen an arm's length from face—at least 20” (508mm).
Position keyboard close enough to create a 90˚ angle in elbow.
Angle Tilt screen to eliminate glare.
Tilt the keyboard back 10° so that your wrists remain fl at.
To Reduce Fatigue
Breathe - Breathe deeply through your nose.
Blink - Blink often to avoid dry eyes.
Break • 2 to 3 minutes every 20 minutes
• 15 to 20 minutes every 2 hours.
For local customer care phone numbers visit: http://contact.ergotron.com
NOTE: When contacting customer
service, reference the serial number.
ENGLISH
6 of 6
888-33-373-G-00 rev. C • 11/14
Loading...