Ergotron Tablet Management Cart / Module Service Manual

888-97-317-G-00 rev E • 12/14

1 of 5

16x

Compatibility:

Made for
iPad Air 2
iPad Air
iPad (4th generation)
iPad mini 3
iPad mini with Retina Display
iPad mini

Apple, iPad, iPad Air, iPad mini, Retina and Macintosh are trademarks of Apple Inc., registered in the U.S. and other countries.

“Made for iPad,” means that an electronic accessory has been designed to connect speci cally to iPad, and has been certi ed by the developer to meet Apple performance standards.
Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards. Please note that the use of this accessory with iPad may a ec t wireless.

Tablet Management Cart / Module

Service Manual

Sync Cable Kit

for iPad®

Make sure the Module power cord is
disconnected from wall power supply
before proceeding.

Unlock the module and open the doors.

Use a Phillips screwdriver to remove the two
screws located on the interior sides of the
module; save screws to reinsert later.

1

2

NOTE: the Module power cord acts
as the connect/disconnect device
switching power o and on.

Length

0.5 m (19.7”)

888-97-317-G-00 rev E • 12/14

2 of 5

1 2 3

4

1 2 3

1 2 3

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

1 2 3 4 5 6 7 8 9 10 11 12

1

Partially slide out the module drawer. You’ll
need to unplug two cables before sliding the
drawer completely out. Open the strap to
access the two cables.

3

Unplug the USB and DC power cables
(push up on the lever under the DC
connector to release). The drawer can
now be removed.

Unwind and remove the existing USB
cables from drawer.

NOTE: Please recyle or dispose the
removed cables in a responsible
manner.

4

5