Ergotron StyleView SV32-S, StyleView SV32-T, StyleView SV32 PHD, StyleView SV32, StyleView SV42 Installation Manual

1 of 10

888-83-065-G-01 rev. E • 03/19

10mm (3/8")
or
8mm (5/16")

SV32-S
SV32-T

SV32

SV32 PHD SV42

3 6 8

www.ergotron.com |

USA: 1-800-888-8458

|

Europe: [phone]

|

China: 400-120-3051

|

Japan: [e-mail]

English, Español, Français, Deutsch, Nederlands, Italiano, Svenska, 日本語, 汉语

10 °C
50 °F

29 °C

86 °F

Relative

Humidity

Range

5-95% rH

Operational

-20 °C

- 4 °F

50 °C
122 °F

Relative

Humidity

Range

5-95% rH

Storage

BATTERY

LEAD

Please dispose of all batteries
in accordance with local law

Two Sealed Lead Acid, Absorbed Glass Mat, 12VDC batteries.

Depends on battery

StyleView® SLA

Change Power System Batteries

· SV32-S

· SV32-T

· SV32

· SV32 PHD

· SV42

English

For the latest User Installation Guide please visit: www.ergotron.com

User's Guide

2 of 10

888-83-065-G-01 rev. E • 03/19

Maintenance & Safety

Color Symbol

Signal

Word

Level of Hazard

Red

DANGER

Indicates an imminently hazardous situation which, if not
avoided, will result in death or serious injury.

Orange

WARNING

Indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injury.

Yellow

CAUTION

Indicates a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury.

None

CAUTION

Used without the safety alert symbol indicates a poten­tially hazardous situation which, if not avoided, may
result in property damage.

Red,

Orange

or

Yellow

Electrical

Indicates an impending electrical hazard which, if not
avoided, may result in personal injury,  re and/or death.

Hazard Symbols Review

The Meaning of Symbols appearing in this Guide, on the Cart or on the Power System
These symbols alert you to a safety condition that demands your attention. You should be able to recognize and understand the signi cance of the following Safety Hazards if
you encounter them on the Cart or within Cart documentation such as this Set-up Guide.

33 Amp-Hour Batteries

BATTERY

LEAD

WARNING: RISK OF ELECTRICAL DISCHARGE

• Do NOT swap battery cables, doing so will cause arcing and trip the circuit breaker.

• Do not remove or replace the batteries while cart is located in an oxygen rich or hazardous environment, arcing may occur and cause combustion.

• Replace  rst battery before removing second battery to reduce the risk of cables touching terminals and causing arcing.

• Always replace both batteries!

• Replace  rst battery before removing second battery.

• Replace batteries with same Amp/Hour rating batteries only.

• Only Ergotron-speci ed batteries may be used in the StyleView Power System. Please call customer care for more details.

• Recycle battery or contact Ergotron for proper battery disposal guidelines.

20 Amp-hour Batteries

BATTERY REPLACEMENT

The power module is congured for two, 33 -Ah batteries.
Only the following batteries are compatible with this
system:

• B&B EP33-12 • SBS S-12330

• Longway 6FM33G • Vision 6FM33D

• Vision 6FM33HD-X • PBQ PBQ33-12L

• Werker WKA12-33C • Werker WKA12-35C

• Duracell Dura 12-35C

Installing batteries other than the 33 -Ah listed above will
void the product warranty. Failure to heed this warning
may result in severe damage to batteries, power module
and possible re hazard.

REMPLACEMENT DE LA BATTERIE

Le module d’alimentation est conguré pour deux batteries 33 A-h.
Seules les batteries suivantes sont compatibles avec ce système :

• B&B EP33-12 • SBS S-12330

• Longway 6FM33G • Vision 6FM33D

• Vision 6FM33HD-X • PBQ PBQ33-12L

• Werker WKA12-33C • Werker WKA12-35C

• Duracell Dura 12-35C

L’installation de batteries autres que les batteries 33 A-h citées
ci-dessus annulera la garantie du produit. Si vous ne vous conformez
pas à cette précaution d’utilisation, les batteries et le module
d’alimentation risquent d’être sérieusement endommagés, ce qui
pourrait provoquer un incendie.

WARNING

AVERTISSEMENT

822-386

www.ergotron.com

3 of 10

888-83-065-G-01 rev. E • 03/19

bacd

12

3

4

5

SV32-S
SV32-T
SV32

Turn o all mounted equipment. Disconnect Power System from

power source.

Turn power system o by holding down the AC Outlet Power button for 1 - 3 seconds. Power light will shut o .

If your cart has circuit breakers, switch them both to "OFF".