Ergotron 47-092-800, 47-093-800 User Manual
100 Series Flat Panel Monitor Pivots
a b
User's Guide
Vertical Surface, Direct Mount
1
2
AB
a b
4X
#8-32 x 5/16"
1x
75-100mm
4x
4x
M4 x 10mm
1x
4X
#8-32 x 3/8"
4x
#8-32
M4 x 10mm
3/32"
888-47-019-02 rev. P • 02/10
1/2"
1/2"
2
1
1 of 8
1
Determine Ergonomic Mounting Height
Set Your Workstation to Work For YOU!
Height Position top of screen slightly below eye level.
Position keyboard at about elbow height with wrists at.
Distance Position screen an arm's length from face—at least 20” (508mm).
Position keyboard close enough to create a 90˚ angle in elbow.
Angle Tilt screen to eliminate glare.
Tilt the keyboard back 10° so that your wrists remain at.
To Reduce Fatigue
Breathe - Breathe deeply through your nose.
Blink - Blink often to avoid dry eyes.
Break • 2 to 3 minutes every 20 minutes
• 15 to 20 minutes every 2 hours.
Learn more about ergonomic computer use at:
www.computingcomfort.org
2
Determine Mounting Confi guration
WARNING
Because surfaces vary widely and the ultimate mounting method is out of Ergotron’s control, it is
!
1.062"
(26.97mm)
imperative that you consult with appropriate engineering, architectural or construction professional
to ensure that your Ergotron mounting solution is mounted properly to handle applied loads.
1.062"
(26.97mm)
NOTE: Fasteners may unwind due to vibration caused by movement of mounting solution over time. Inspect mounting
solution for loose fasteners on a routine basis. If desired, apply a light duty thread locking adhesive to fasteners before
installation to prevent back-out.
888-47-019-02 rev. P • 02/10
2 of 8
3
Mount Pivot
4X 4X
a
#8-32 x 5/16"
b
#8-32 x 3/8"
4
Attach Monitor
a
c
75 mm
4
+
b
d
100 mm
5
X mm
888-47-019-02 rev. P • 02/10
3 of 8
Loading...