Ergotron 45-007-099 User Manual

User's Guide

400 Series Flat Panel Monitor Arm

Rotate Mount Double Pivot P/L

< 23lbs. (10.44 kg)

For the latest User Installation Guide please visit: www.ergotron.com

888-45-031-01 rev. F • 03/15

1 of 10

Hazard Symbols

Symbol Signal Word Level of Hazard

Review

These symbols alert users of a safety condi­tion that demands attention. All users should
be able to recognize and understand the
signifi cance of the following Safety Hazards
if encountered on the product or within the
documentation. Children who are not able
to recognize and respond appropriately to
Safety Alerts should not use this product with­out adult supervision!

Safety

Important! You will need to adjust this product after installation is complete. Make sure all your
equipment is properly installed on the product before attempting adjustments. This product should
move smoothly and easily through the full range of motion and stay where you set it. If movements
are too easy or diffi cult or if product does not stay in desired positions, follow the adjustment
instructions to create smooth and easy movements. Depending on your product and the adjustment,
it may take many turns to notice a difference. Any time equipment is added or removed from this
product, resulting in a change in the weight of the mounted load, you should repeat these adjustment
steps to ensure safe and optimum operation.

NOTE

CAUTION

WARNING

ELECTRICAL

A NOTE indicates important information that helps you
make better use of this product.

A CAUTION indicates either potential damage to
hardware or loss of data and tells you how to avoid the
problem.

A WARNING indicates either potential for property dam­age, personal injury, or death.

An Electrical indicates an impending electrical hazard
which, if not avoided, may result in personal injury,  re
and/or death.

Warning: Because mounting surface materials can vary widely, it is imperative that you make sure mounting surface is strong

enough to handle mounted product and equipment.

Caution:
To avoid the potential to pinch cables it is important to follow the cable routing instructions in this manual. Failure to follow
these instructions may result in equipment damage or personal injury.

2 of 10

888-45-031-01 rev. F • 03/15

2

1

Components

AB CD

1

2

3

4

1x

1x

4x

#8-32

4x

M4 x 10mm

75-100mm

1x

3/32"

1x 4x 2x

1/8"

#10-24x3/8"

1x

4x 2x

3/16"

4x

M4 x 10mm

#6-32x1/2"

Mounting Height for Ergonomic Workstation

This mounting height is a recommendation for an ergonomic workstation that accommodates user
heights of 5’1” - 5'11". If user heights are di erent than this, you should change mounting height to
accommodate user heights. (Change mounting height one inch for every one inch di erence in user heights).

6”

(152 mm)

Mounting height assumes
there is a 6” (152 mm)
distance between the center
of your monitor mounting
holes and the top of
the screen. If your
distance is smaller, you
should increase mounting
height accordingly,
if your distance
is larger, you should
decrease your mounting
height accordingly.

44”

(1118mm)

5’1” - 5’11”

(156-180cm)

CAUTION: DO NOT EXCEED
MAXIMUM LISTED WEIGHT
CAPACITY. SERIOUS INJURY
OR PROPERTY DAMAGE MAY
OCCUR!

< 23lbs. (10.44 kg)

888-45-031-01 rev. F • 03/15

3 of 10