Keyboard Drawer
Assembly Instructions
Hello! Thank you for choosing Anthro.
Before beginning installation of your Keyboard Drawer, please take a moment to review the parts listed to verify that
your shipment is complete.
The Cart (shown shaded) is not included with this accessory. An electric drill &
mounting holes for your Keyboard Drawer. It may also be helpful to review the assembly instructions of all Anthro
products you purchased and are planning to include in this installation.
SAVE THESE INSTRUCTIONS!
1
/8” drill bit may be required to drill the
Built with Anthro-DNA™
01
02
Component list for part #’s 18xx, 20xx & 30xx.
01–Caddy Glides ...................... Qty. 1 pr. .........225-5190-00
02–Keyboard Drawer ....................Qty. 1................(see below)
18”W X 11”D (18xx) ............ ........................100-6489-xx
20”W X 11”D (20xx) ........... ........................100-6359-xx
30”W X 11”D (30xx) ........... ........................100-6304-xx
05
04
03
03–3/4” Wood Screws ............... Qty. 12 .......... 325-5106-00
04–10-24 X
05–10-24 Acorn Nuts............... Qty. 4............. 325-5023-00
A 1/8” Hex Key, has been provided to assist you in this assembly.
3
/8” Cap Screws...... Qty. 4.............325-5232-00
300-5215-00 rev. D
• /
Step 1
Align a Mounting Bracket with a Glide as shown. Insert
a Pan Screw through the selected hole of the Bracket &
Glide, capturing on the opposite side with a Keps Nut.
Repeat for remaining Brackets & Glides.
Cap
Screw
Glide-L
Tabs
Rubber Bumper
Glide-R
Cap Screw
325-5232-00
AcornNut
325-5023-00
Step 2
Place the Keyboard Drawer between both Glides.
Align the predrilled holes on the Drawer with the holes
on each of the tabs (located on the Glides). Secure using
a total of four Wood Screws.
Wood Screw
325-5106-00
Step 3
Pull the Drawer out. Align the two holes on each Bracket
with the predrilled holes on a Shelf. Secure using a total
of eight Wood Screws.
Congratulations! Your assembly is complete.
Nut
Tabs
Glide
Rubber Bumper
Wood Screw
Tabs
Pull
Drawer
out
Bracket
Glide-L
Assembled
AnthroCart
Shelf
Acorn
Glide-R
Curved Edge of
Keyboard Drawer
If your Shelf is not predrilled: place the Keyboard Drawer in the desired location.
Mark all eight holes, then carefully drill using a 1/8” drill bit (3/4” deep). TIP: Place
a small amount of masking tape at 3/4” on your drill bit to guide the hole depth.
Wood Screw
Wood Screw
325-5106-00
For Warranty visit: www.ergotron.com/warranty
For Service visit: www.ergotron.com
For local customer care phone numbers visit: http://contact.ergotron.com
© 2018 Ergotron, Inc. All rights reserved.
All trademarks are the property of their respective companies.
Anthro is a registered trademark and brand of Ergotron Inc.
Anthro-DNA is a trademark of Ergotron Inc.
300-5215-00 rev. D
• /
Loading...