EPSON
Material Safety Data Sheet
1. Identification of The Substance/Preparation and of The Company/Undertaking
1.1. Identification of the preparation: Epson Ink Cartridge T6243
1.2. Use of the substance/preparation: Inkjet Printing
1.3. Company/undertaking identification
Manufacturer/Distributor: SEIKO EPSON CORPORATION
Address: 80 Harashinden, Hirooka,
Shiojiri-shi, Nagano-ken, 399-0785
JAPAN
TEL: +81-263-52-2552 FAX: +81-263-53-3702
e-mail: msds_hro@exc.epson.co.jp
Date Prepared: December 14, 2007
Date Revised:
1.4. Emergency telephone: +81-263-52-2552 (Mon-Fri, 9AM-5PM JST)
2. Hazard Identification
2.1. Emergency Overview:
Ink component is a magenta liquid that causes eye, nose or throat irritation, and that effects anesthesia,
if inhales. Ink may flash, when under high temperature. Avoid contact with eyes or clothing. In
the case of skin contact, wash with soap and water. Keep out of reach of children.
2.2. Potential Health Effects:
Eyes: Ink contact with eye will be irritating. See Section 11 for Toxicology .
Skin: Ink contact with skin may cause minimally irritation. See Section 11 for Toxicology.
Inhalation: Intentional exposure to ink vapors (mist) will cause respiratory irritation and anesthesia. See Section
11 for Toxicology.
Ingestion: May cause upset stomach. See Section 11 for Toxicology.
3. Composition/Information on Ingredients
This is a solvent ink formulation
Ink Composition
Proprietary pigment – 1 – 5
Synthetic polymer – 1 – 5
Diethylene glycol diethyl ether 112-36-7 55 – 65
Gamma-butyrolactone 96-48-0 10 – 20
Tetraethylene glycol, dimethyl ether 143-24-8 10 – 20
Tetraethylene glocol, monobutyl ether 1559-34-8 1 – 5
Additives – 1 – 5
MSDS T6243 Version 6.0
Page 1 of 4 Release Date December 14, 2007
CAS No. % By Weight
EPSON
4. First Aid Measures
4.1. Eyes: Immediately flush with room temperature, low pressure and clean water for at least 15 minutes. Seek
medical attention if eye irritation continues.
4.2. Skin: Wash surface areas with soap and water. Wash soiled clothing before rewearing. Consult a physician
if irritation continues.
4.3. Inhalation: Remove subject to ventilated fresh air. If not breathing, give artificial respiration right away. If
breathing is difficult, give oxygen. Seek immediate medical attention.
4.4. Ingestion: Seek medical advice; and attention if stomach continues to be upset.
5. Fire Fighting Measures
5.1. Flammability: Combustible liquid under Hazard Communication Standard (HCS, U.S.A).
See Section 9 for Flash Point.
5.2. Extinguishing Media: Water spray, dry chemical, carbon dioxide or, alcohol foam
5.3. Fire Fighting Instructions: Extinguish to use fire fighting media or plentiful fog water. Put protection wear
without fail in case of fire fighting work; do not work in the leeward.
6. Accidental Release Measures
6.1. Personal protections: Removed the person of the leeward. Keep away the person from periphery of
the place of the leakage. Ventilate sufficiently during clean-up in case of inside
of a house.
6.2. Methods for cleaning up: If a spill occurs, use sponges to wipe-up ink, then rinse area with damp cloth.
Place waste in closed container for disposal. Do not dispose of waste to the sewer.
Wash hands with soap and water.
7. Handling And Storage
7.1. Handling: Use proper ventilation and no fire in work place.
conductivity in case of work.
Keep out of reach of children and do not drink ink. Do not
dismantle cartridge. Make sure cartridge is dry before insertion into printer housing.
7.2. Storage: Do not store the cartridge in high or freezing temperatures. Keep cartridge out of direct sunlight.
Do not store cartridges with oxidizing agents or explosives.
7.3. Specific use(s): Not specified
8. Exposure Controls and Personal Protection
8.1. Exposure limit values: No data available
8.2. Exposure Controls:
8.2.1. Occupational exposure control
Diethylene glycol diethyl ether (CAS No. 112-36-7)
California OELs (California Code of Regulations, Title 8, Section 5155. Airborne Contaminants)
The 8-Hour TWA Exposure Value: 5 ppm
The 8-Hour TWA Exposure Value: 33 mg/m
3
8.2.1.1. Respiratory protection
Not required under suitable use as setting the cartridge on the printer.
8.2.1.2. Hand protection
Not required under suitable use as setting the cartridge on the printer.
8.2.1.3. Eye protection
Not required under suitable use as setting the cartridge on the printer.
8.2.1.4. Skin protection
Put protection wear that has electrical
MSDS T6243 Version 6.0
Page 2 of 4 Release Date December 14, 2007
EPSON
Not required under suitable use as setting the cartridge on the printer.
8.2.2. Environmental exposure control
Not established
8.3. Engineering Controls
Proper ventilation
9. Physical and Chemical Properties of Ink Formulation
9.1. General information
Appearance: Magenta Liquid
Odor: Slightly
9.2. Important health, safety and environmental information
pH: Not applicable
Boiling point: No data available
Melting point: No data available
Flash point: about 71°C (Closed cup)
Autoflammability: None
Explosive properties: 1.4~6.9v/v% as Gamma-butyrolactone
Oxidizing properties: None
Vapor density: Greater than 1 (air = 1)
Relative density: No data available
Solubility in water: Soluble
Solubility in fat: No data available
Partition coefficient: No data available
Viscosity: No data available
9.3. Other information Not specified
10. Stability and Reactivity
Stability Stable under normal temperature
Hazardous polymerization No data available
10.1. Conditions to avoid: High and freezing temperatures
10.2. Materials to avoid: Oxidizers and explosives
10.3. Hazardous decomposition products: No data available
11. Toxicology and Health Hazards
*Based on toxicology data of chemically similar material
Routes Of Overexposure: Eye, skin, inhalation, and oral
Acute Health Hazards:
• Overexposure of eye surface to ink may be mildly irritating
• Overexposure of skin to ink contact may cause irritation and in some people swelling and redness
• Intentional inhalation overexposure to ink vapors may result in respiratory tract irritation and anesthesia
• Intentional or accidental oral ingestion may cause an upset stomach
Chronic Health Hazards: None known
Mugtagenicity: Negative (by Ames Test)*
Carcinogenicity: Not contain any substances listed in IARC Monographs (1,2A and 2B)
MSDS T6243 Version 6.0
Page 3 of 4 Release Date December 14, 2007
EPSON
Toxicity Data: Oral LD50 Dermal LD50 Inhalant LC50
> 2500 mg/kg (Rat)* > 2000 mg/kg (Rat)* No data available
Eye irritating: Moderate irritant (Rabbit, OECD 405)*
Skin irritating: Mild irritant (Rabbit, OECD 404)*
Skin sensitizing: Non-sensitizer (LLNA, OECD 429)*
12. Ecological Information
12.1. Ecotoxicity No data available on the adverse effects of this ink on the environment
12.2. Mobility No data available on the adverse effects of this ink on the environment
12.3. Presistence and degradability
No data available on the adverse effects of this ink on the environment
12.4. Bioaccumulative potential
No data available on the adverse effects of this ink on the environment
12.5. Other adverse effects No data available
13. Disposal Considerations
Disposal should be in accordance with federal, state, and local requirements.
14. Transportation Information
UN Class/UN Number: Not applicable
15. Regulatory Considerations
US Regulation:
TSCA Section 4(a) Final Test Rules Regulated Not regulated
TSCA Section 8(a) Preliminary Assessment Information Rule(PAIR) Not regulated
TSCA Section 8(a) Inventory Update Rule:
Subject to a Special Regulatory Action under TSCA (2002 EPA Instructions, App. B) Not regulated
TSCA Section 12(b) One-Time Export Notification Regulated Not regulated
California Proposition 65: Not regulated
EU Information
Symbols and indication according to 1999/45/EC:
This ink does not meet the criteria for classification as dangerous.
16. Other Information
This “Material Safety Data Sheet” contains health, safety, and environmental information. It does not replace any
precautionary language or use and disposal information which accompanies the product. The information
contained herein is believed to be accurate at the time of preparation, but should only be used as a guide. It is
subject to revision from time to time. EPSON does not warrant the completeness or accuracy of the information
contained herein.
MSDS T6243 Version 6.0
Page 4 of 4 Release Date December 14, 2007
Loading...