Epson T6241 User Manual
Product Information Sheet
1. Article and Corporate Identification
Product: Epson Ink Cartridge T6241
for use with Epson Stylus Pro GS6000
Printers
Distributor: Epson America, Inc.
3840 Kilroy Airport Way
Long Beach, CA 90806
United States
Tel: 562-276-1369
Fax: 562-997-5799
The EPSON T6241 Ink Cartridge
Epson Quick-Dry Ink is engineered to
provide superior photo quality results.
2. Composition Information
This is a solvent ink formulation
Ink Composition CAS No.
Carbon black
Proprietary synthetic polymer
Diethylene glycol diethyl ether
γ-Butyrolactone
Tetraethylene glycol dimethyl ether
Tetraethylene glycol monobutyl ether
Proprietary organic additives
1333-86-4
-
112-36-7
96-48-0
143-24-8
1559-34-8
-
% By Weight
<6%
<6%
55 – 65%
10 - 20%
10 - 20%
<6%
<6%
3. Hazard Identification
3.1 Emergency Overview: Ink component is a light black liquid that may cause eye irritation. Avoid contact with
eyes or clothing. In the case of skin contact, wash with soap and water. Keep out of reach
of children.
3.2 Potential Health Effects:
Eyes: Ink contact with eye may be mildly irritating. See Section 11 for Toxicology.
______________________________________________________________________________________________________
PIS # T6241 Version 3.6 (USA)
Page 1 of 4 Release Date 05/13/08
Skin: Ink contact with skin may cause irritation, swelling, or redness. It is not expected to cause an allergic skin
reaction. See Section 11 for Toxicology.
Inhalation: Intentional exposure to ink vapors may cause respiratory irritation. See Section 11 for Toxicology.
Ingestion: May cause upset stomach. See Section 11 for Toxicology.
4. First Aid Measures
4.1 Eyes: Immediately flush with room temperature, low pressure, clean water for at least 15 minutes. Seek medical
attention if eye irritation continues.
4.2 Skin: Wash surface areas with soap and water. Wash soiled clothing before re-wearing. Seek medical attention if
irritation continues.
4.3 Inhalation: Remove subject to ventilated fresh air. Consult physician if necessary
4.4 Ingestion: Seek medical attention if stomach continues to be upset.
5. Fire Fighting Measures
Flammability: Flash point is 71 deg. C (closed cup, ASTM D3278); combustible liquid under Hazardous Communication
Standard (HCS, USA)
Extinguishing Media: Dry chemical, carbon dioxide, foam, or water
Fire Fighting Instructions: No special fire fighting procedures are required other than breathing apparatus and PPE. No
special explosion hazards are known.
6. Accidental Release Measures
If a spill occurs, use sponges to wipe-up ink, then rinse area with damp cloth. Place waste in closed container for
disposal. Use proper ventilation. Do not dispose of waste to the sewer. Eye or skin protection required during cleanup. Wash hands with soap and water.
7. Precautions for Safe Han dling and Use
Keep out of reach of children and do not drink ink. Do not store the cartridge in a high or freezing temperatures.
Keep cartridge out of direct sunlight. Do not dismantle cartridge. Do not store cartridges with oxidizing agents or
explosives. Make sure cartridge is dry before insertion into printer housing. Store in ventilated area without
direct/indirect flame.
8. Exposure Controls and Personal Protection
Engineering Controls: Use in properly ventilated area
Exposure Controls: Use in properly ventilated area
California OEL for Diethylene glycol diethyl ether (CAS No. 112-36-7)
8-Hour TWA Exposure Value: 5ppm or 33 mg/m3
Personal Protection: None required when cartridges are used as intended
______________________________________________________________________________________________________
PIS # T6241 Version 3.6 (USA)
Page 2 of 4 Release Date 05/13/08
Loading...