Epson Stylus CX6400 Start Here Card

Start Here

EPSON Stylus®CX6400

1

CPD-16930R1 4049040-00 XXX

1 Make sure you have all the parts shown here. If any parts are missing,

Unpack

contact EPSON®as described on the back of this sheet.

EPSON Stylus CX6400

Software
CD-ROM

Quick Reference

Paper support

2 Remove all blue packing tape from the printer.

3 Lift up the scanner section. If it doesn’t open, make sure you have

removed all the tape.

Ink cartridges Feeder guard

4 Peel off the tape from the ink cartridge holder.

5 Close the scanner section.

2

1 Insert the paper support into the slots behind the printer, as shown.

2 Lower the feeder guard into the slots behind the scanner lid.

Attach the Parts

(Insert the hinges on the feeder guard into the corresponding
slots on the printer.)

3

1 Plug the Stylus CX into a grounded electrical outlet.

2 Press and hold the On button until the green lights come on.

Plug In and Turn On

Caution: Do not connect the USB cable until instructed.

On button

4

1 Wait until you see “Initial Charge” displayed on the control panel.

2 Lift up the scanner section.

Install Ink Cartridges

3 Shake the package of ink cartridges four or five times.

Then remove the cartridges from the package.

Don’t touch the green part

Caution: You must install all cartridges and leave them installed
for all types of printing. To avoid damaging the Stylus CX, never
move the print head by hand.

4 Open the cartridge cover.

5 Place each cartridge in its holder.

6 Press down on each cartridge until it clicks into place.

continue