Epson CX11NF, CX11N User Manual

Epson AcuLaser® CX11N/CX11NF

Packing Instructions

If you need to ship the Aculaser CX11N/CX11NF, follow these steps to package it to
prevent damage during transit:

1. Make sure the CX11N/CX11NF is turned on, then press the Setup button

The Setup light turns on and the LCD screen displays Setup Mode for a few
seconds, then changes to the Setup menu screen.

2. Use the u or d button to select Scan Settings, then press the r button.

3. Use the u or d button to select Carriage Lock, then press the r button.

4. Set the transportation lock on the left side of the document table to the locked
position.

5. Slowly flip back the scanner until it
stops.

6. Close the output tray extension, then
lift up cover B.

7. Pull up the orange lever inside
cover B.

8. Lift out the photoconductor using its
handle.

9. Package the photoconductor in a
separate box or bag large enough to
hold it.

Note:

Do not remove the toner cartridges.

10. Flip down the orange lever, then close cover B.

11. Slowly push down the scanner to its original position.

Cover B

12. Turn off the CX11N/CX11NF and remove the following items:

■ Any loaded paper in the MP tray

■ Optional paper cassette unit (if installed; see the online User’s Guide for more

information)

■ USB cable

■ Power cord

13. Use shipping tape to tape the scanner and
supporting foam to the printer as shown:

Caution:

Don’t forget to place the foam in-between
the scanner and printer; otherwise, the
scanner hinges may be damaged during
shipping.

14. Place the CX11N/CX11NF in the original
lower box housing.

Warning:

The back side of the CX11N/CX11NF is
heavier than the front, so prepare for this
difference as you lift. Two people should lift
the CX11N/CX11NF.

Foam