EPSO
14” Super VGA
Color Monitor
(Model A881391)
User’s Guide
FCC COMPLIANCE STATEMENT
FOR AMERICAN USERS
This equipment has been tested and found to comply with the limits for a class B digital
device, pursuant to Part
reasonable protection against harmful interference in a residential
15 of the FCC Rules. These limits are designed to provide
installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is
no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
user is encouraged to try to correct the interference
by one or more of the following
and on, the
measures:
❏ Reorient or relocate the receiving antenna.
❏ Increase the separation between the equipment and receiver.
❏ Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
❏ Consult the dealer or an experienced radio/TV technician for help.
NOTICE
(1) Any changes or modification not expressly approved by the party responsible for
compliance could void the user’s authority to
operate the equipment
(2) Shielded interface cables and AC power cord must be used in order to comply with the
emission limits.
FOR CANADIAN USERS
This digital apparatus does not exceed the Class B limits for radio noise emissions from
digital apparatus as set out in the radio interference regulations of the Canadian
Department of communications.
Le présent appareil
numérique n’éme-t pas de bruits radioélectriques dépassant les limites
applicables aux appareils numériques de Classe B prescrites dans le réglement sur le
brouillage radioélectrique édicté par le Ministére des Communications du Canada.
IMPORTANT NOTICE
DISCLAIMER OF WARRANTY
Epson America makes no representations or warranties, either express or implied, by or
with respect to anything in this manual,
and shall not be liable for any implied warranties
of merchantability and fitness for a particular purpose or for any indirect, special, or
consequential damages. Some states do not allow the exclusion of incidental or
consequential damages, so this exclusion may not apply to you.
COPYRIGHT NOTICE
All rights
reserved. No part of this publication may be reproduced, stored in a retrieval
system, or transmitted, in any form or by any means, electronic, mechanical,
photocopying, recording, or otherwise, without the prior written permission of Epson
America, Inc. No patent liability is assumed with respect to the use of information
contained
herein. Nor is any liability assumed for damages resulting from the use of the
information contained herein. Further, this publication and features described herein are
subject to change without notice.
TRADEMARKS
EPSON is a registered trademark of Seiko Epson Corporation.
EPSON Connection is
a service mark of Epson America, Inc.
General notice: Other product names used herein are for identification purposes only and
may be trademarks of their respective companies.
The Energy Star emblem does not represent EPA endorsement of any product or service.
Copyright
© 1994 by Epson America, Inc.
Torrance, California, USA
ii
400297000
l/94
Important Safety Instructions
Although this monitor is designed to assure your safety, improper use can
cause electric shock or fire hazard. In order not to defeat the safeguards
incorporated in the monitor, observe the following safety instructions:
Read all of these instructions and save them for later reference.
1.
Follow all warnings and instructions in this manual and marked on the
2.
monitor.
The monitor contains shock hazard potential. Do not attempt to open or
3.
remove any covers, and do not attempt to service the monitor yourself.
Refer all servicing to authorized service personnel.
Never push objects of any kind into the monitor through cabinet slots.
4.
Do not expose the monitor to liquids, such as ram or spills.
5.
Do not place the monitor on an unstable cart, stand, or table, and be
6.
careful not to drop it.
Do not place the monitor near a heating appliance or in direct sunlight.
7.
Intense heat can damage the monitor’s circuitry.
Slots and openings on the top, sides, and back of the cabinet are provided
8.
for ventilation; do not block or cover these openings. Do not place the
monitor in a built-in insulator, such as a bookcase, unless proper
ventilation is provided.
Power supply voltages outside the monitor’s specified line voltage range
9.
may harm the monitor. The monitor should be operated from the type
of power source indicated on the rear panel marking label.
Make sure the combined amperage rating for all products plugged into
10.
the wall outlet used for the monitor does not exceed the amperage
rating of the wall outlet.
Use only the power cord supplied with the monitor. If you must use
11.
another power cord, make sure it meets the applicable standards
(UL/CSA).
Do not overload the computer inlet and extension cords as this can result
12.
in fire or electric shock.
Be careful not to damage the power cord or plug.
13.
. . .
111
14.
Do not allow anything to rest on the power cord. Do not place a cord
where it may be stepped on.
15.
Do not replace the video interface cable with a non-shielded cable.
16.
Unplug the monitor from the computer and the wall outlet before
cleaning. Use a damp cloth for cleaning.
17.
Excessive brightness for long periods may permanently imprint an image
on the screen.
18.
To avoid picture distortion or color disturbance, do not put devices that
generate magnetism (such as telephones, televisions, speakers, or
magnetic screwdrivers) near the monitor.
19.
When the monitor will not be used for a long period of time, turn it off
by pressing the power button. (Always wait at least five seconds before
you turn it back on.)
20.
Unplug the monitor from the computer and the wall outlet and refer
servicing to authorized service
personnel
under the following
conditions:
If the power cord or plug is damaged.
A.
If the monitor has come into contact with any liquids, such as rain or
B.
spills.
If the monitor does not operate normally when the operating
C
instructions are followed. Adjust only those controls that are
covered by the operating instructions; improper adjustment of
other controls may result in damage and will often require
extensive work by a qualified technician to restore the product to
normal operation.
iv
If the monitor has been dropped or the cabinet or glass faceplate has
D.
been damaged.
If the monitor exhibits a distinct change in performance.
E.
Importantes mesures de sécurité
Bien que le moniteur soit conçu pour assurer votre sécurité, un usage
incorrect peut provoquer une décharge électrique ou poser un risque
d’incendie. Pour ne pas aller
incorporées dans le moniteur, veuillez bien observer ces instructions:
tire attentivement les instructions qui suivent. Les conserver en lieu sûr.
1.
Observer les avertissements marqués sur le moniteur et suivre
2.
rigoureusement les instructions contenues dans le manuel.
Le moniteur pose des risques de décharge électrique. Ne pas tenter de
3.
soulever ou d’enlever les couvercles; ne pas essayer de réparer le
moniteur soi-même; s’adresser au personnel de service autorisé par le
fabricant
Ne jamais rien introduire dans les ouvertures du coffre.
4.
Protéger le moniteur de tout contact avec l’eau, la pluie, les boissons
5.
renversée, etc.
Ne pas laisser tomber l’appareil. Éviter de le placer sur un meuble instable.
6.
Ne pas placer le moniteur a proximité d’un appareil de chauffage, ni en
7.
plein soleil. La chaleur intense peut endommager les circuits.
Il est important de ne pas bloquer les ouvertures situées sur le dessus et
8.
derrière l’appareil: ce sont des prises d’air qui en assurent l’aération. Ne
pas placer le moniteur
d’une bibliothèque fermée, à moins d’y avoir une bonne circulation
d'air.
Un voltage inférieur ou supérieur à celui qui est spécifiquement désigné
9.
pour le moniteur pourrait l’endommager. Utiliser seulement la source
d’électricité indiquée sur l’étiquette à l’arrière de l’appareil.
L’ampérage total de toutes les pièces branchées sur le mêne socle ne doit
10.
pas dépasser la capacité en ampères du socle.
Utiliser seulement le cordon électrique dont le moniteur est muni. S’il est
11.
nécessaire de se servir d’un autre cordon, s’assurer que les standards de
fabrication sont conform& aux règlements en vigueur (UL/CSA).
Ne pas surcharger les prises de courant ni les cordons prolongateurs, car
12.
cela pourrait mettre le feu ou causer une décharge électrique.
à
l’encontre des mesures de protection
à
l’intéieur d’un placard, ou sur les rayons
Faire attention à ne pas abîmer le cordon électrique ni la prise de courant.
13.
Ne rien mettre ni laisser sur les cordons électriques. Pour éviter de leur
14.
marcher dessus, ne pas les installer dâts un endôit de passage.
Ne pas remplacer un cordon d’interface par un cordon non protégé.
15.
Débrancher le moniteur du socle et de l’ordinateur avant de le nettoyer.
16.
Utiliser seulement un chiffon humide.
Si la luminosité de l’écran reste à sa plus haute intersité pendant de
17.
longues périodes, l’image pourrait y rester imprimée de façon
permanente.
Pour éviter les deformations de l’image ou les perturbations de couleur,
18.
ne pas placer de sources de magnétisme telles que téléphones, postes de
télévision, ou haut-parleurs
Lorsqu’on ne devra pas utiliser le moniteur pendant de longues
19.
à
proximité du moniteur.
périodes, l’éteindre en pressant l’interrupteur. Toujours attendre au
moins cinq secondes avant de le remettre en marche.
Debrancher le moniteur et s’adresser au personnel de service autorisé
20.
dans les conditions suivantes:
A.
Si le cordon est effiloché ou la prise est endommagée
B.
Si le moniteur est entré en contact avec des liquides.
C.
Si le moniteur ne répond pas normalement aux commandes passées
en suivant les instructions. Ajuster uniquement les contrôles décrits
dans les instructions; il est possible de gravement endommager
l’appareil en touchant les autres, ce qui pourrait nécessiter
l’intervention d’un technicien qualifié pour le remettre en état de
marche.
D.
Si le moniteur est tombé ou si l’éran ou le coffre ont été
endommagés
E.
Si la performance du moniteur est nettement différente de l’ordinaire.
Contents
Introduction
Energy Star Compliant
Where to Get Help
CompuServe On-line Support
Unpacking the Monitor
Setting Up the Monitor
Attaching the Tilt and Swivel Base
Selecting a Location for the Monitor
Connecting the Monitor to Your Computer
Turning On the Monitor
Adjusting the Monitor Controls
Cleaning the Monitor
Troubleshooting
Specifications
...............................
.......................
...........................
...................
.........................
.........................
........................
....................
..........................
.............................
..............................
................
...............
...........
1
1
2
3
4
4
5
7
7
9
9
11
11
13
vii
lntroduction
Your EPSON® Super VGA Color Monitor (model A881391) is
compatible with all IBM
from 31 to 48 KHz. It offers the following features:
l4-inch, analog color CRT display with non-glare surface
❏
High-resolution display of up to 1024 x 768 pixels,
❏
non-interlaced
Six user-adjustable controls: brightness, contrast, horizontal
❏
centering, horizontal size, vertical centering, and vertical
size
Universal power supply with automatic line voltage
❏
selection between 100 and 240 volts
❏
Energy Star compliant
Tilt and swivel base.
❏
This manual describes how to set up and use the monitor. It
also provides troubleshooting information and specifications.
®
8514A, VGA, and Super VGA modes
Energy Star Compliant
Your EPSON monitor complies with the U.S. Environmental
Protection Agency’s Energy Star program, which promotes the
manufacture of energyefficient printers, computers, and
monitors. The EPSON Super VGA Color Monitor conserves
electricity by automatically entering a low-power, standby
mode when the computer stops sending certain signals to the
monitor.
14” Super VGA Color Monitor
1
Loading...