Epivalley Co., Ltd has the copyright for this manual.
This manual should not be reproduced or distributed with no prior written
consent by Epivalley Co., Ltd.
Registered Trademark
The registered trademark stated in this manual is the registered trademark
owned by the corresponding company.
Confidential & Proprietary
This manual is the technical property of Epivalley Co., Ltd and it is prohibited to copy or utilize the manual
with no prior consent by the technical data department.
- 2 -
- 3 -
Table of Contents
Cautions for Safety.......................................................................5
The cautions for safety are the contents to keep the safety of users and to
prevent possible loss in property or convenience caused by accidents. The
product should properly be used after sufficient understanding of the contents.
Warning
z Do not discretionally disassemble, modify, or repair the product.
z Do not use the product if possible at the place where the use of
handsets is prohibited.
z Use the product according to the rules and regulations of hospitals or
medical institutions when using the product in such places.
z Do not use the product in the Airplane.
z Keep the product and accessories out of children’s reach.
z Do not touch or use with wet hands.
z Do not use the product outside in the thundering or lightning weather.
Cautions
z Be careful not to give impact to the product and not to throw (or drop)
the product because the product may be broken or deformed.
z When a trouble is occurred with the product, visit a designated service
center to receive the service.
z Keep the USB port of the product clean always.
z The data to use the product is stored in USIM CARD; be careful to
avoid possible damage to USIM CARD.
z Do not use or keep the product with magnetic storage media together.
z Do not use or keep the product at the very hot or very cold place or the
place with large variation of temperature.
z If the model is disconnected from PC in switch-on status, the data may
be damaged; disconnect the model from the PC after the programs are
terminated and the power LED is turned off.
- 5 -
z When the product is used in connection with a notebook with use the
battery only, the battery of the notebook may be somewhat rapidly
discharged due to additional consumption of the power by the product.
- 6 -
Introduction
Thanks you for purchasing SDT1100 of Epivalley Co., Ltd.
SDT1100 is a USB Modem by
HSDPA
method to use wireless internet anytime
and anywhere with no limit in time or place.
* HSDPA (High Speed Downlink Packet Access): This is the mobile communication
method for sending/receiving data at the speed significantly faster than that of W-CDMA
or CDMA.
Specific Features
* General Features
- USIM Support
- Internet, Intranet
- SMS
- Address
- Connection logs
* Mechnical Features
- Compatible microSD card
- Main Intenna
- UMTS Diversity Intenna (2100MHz)
- 7 Colors LED
- Dimension: 38mm(W) × 16mm(H) × 78mm(D)
* Data Rate
- Download: Up to 7.2 Mbps
- Upload: Up to 384 Kbps
* Frequency Band
- GSM: 850 / 900 / 1800 / 1900 MHz
- UMTS: 850 / 1900 / 2100 MHz
- 7 -
Configuration
The configuration of SDT1100 product is as shown below:
The configuration of the product may be somewhat changed wit no prior notice to improve
the functions of the product.
Condition for Use
The minimum specification of the PC to use SDT1100 is as described below:
z Operating System: Windows® 2000, XP or Vista(32bit, 64bit), Mac® OS X
z CPU: Pentium 4, 1 GHz or above
z Memory: 128MB RAM or above
z Hard disk space: 100MB or above
z Connection port: USB slot A-Type
- 8 -
Name of Each Part
Front Part Lateral Part
Lower Part
- 9 -
Installing Program
S/W is included in USB Modem.
1. When SDT1100 is inserted into the USB port of the PC to use SDT1100, the
installation program is automatically run.
Note: If SDT1100 Dialer program is already installed, the program is not automatically run.
If you want to reinstall the program, manually start the installation program with use of explorer.
2. When the installation is automatically started, below-shown screen is
displayed. Choose the setup language and click [OK] button.
Note: If the installation is not automatically run, doubleclick “setup32.exe” file in CD. (In case of
Vista 64, setup64.exe)
3. To install the program, files are copied from Modem to PC.
- 10 -
4. When “Welcome to the Installshield Wizard” message is displayed, click
[Next] button.
5. Designate the destination folder to install the program and click [Next] button.
Destination folder of
the program
- 11 -
6.Click [Install] button to install the program.
7. Files are copied from Modem to PC.
- 12 -
8. Program is completely installed. Click [Finish] button to finish the program
installation.
- 13 -
Loading...
+ 29 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.