ENUSTECH CODAWHEEL Users Manual

CODAWheel Manual

CODAWheel is a remote control designed for smartphones, based on Bluetooth Low
Energy (BLE) technology. Its primary purpose is to facilitate the use of voice
command services such as Siri® or Google Now® in Bluetooth hands-free mode in
your car. Further, you can also edit its settings to perform various tasks using the
configuration app, CODAWheel.

Minimum Requirements

- iOS® ver 7.0 and up with Siri or Android® Kitkat with Google Now and support for

BLE.

Factory-builtor 3rd party in-car Bluetooth hands-free system/device recommended

-

for voice command inside a vehicle.

1. Activating CODAWheel

Turn power on by sliding the button on the back of CODAWheel. Through Bluetooth
Low Energy (BLE) technology, CODAWheel’s stand-by time is expected to last
several years and therefore, turning off power is virtually not necessary under normal
conditions. You may attach double sided tapes or Velcro® sticky fastener to the back
of the CODAWheel for mounting purposes.

2. Pairing CodaWheel

Before pairing, make sure that CODAWheel is not connected to any smartphone. If
connected, it will not enter the pairing mode. To disconnect CODAWheel, turn
Bluetooth off on the smartphone.

Press the button on CODAWheel for 15 seconds until green and red LEDs flash
alternately. CODAWheel is now ready for pairing. From your smartphone, go to
Bluetooth settings and initiate pairing. For step-by-step instructions, please refer to
your smartphone manual.

3. Configuration Application

CODAWheel is pre-configured to emulate smartphone’sHome button.Using the
configuration application, you can change its settings to perform tasks such as:

- Voice command:Click to start Siri or Google Now.

- Voice command with music control:Emulate headphone in-line remote button.

- Camera shutter release:With a camera application running, click to take photos.

- Compatible applications:Use CODAWheel as a remote button for 3

rd

party

applications. Refer to the application manual for details.

The name of the configuration application is CODAWheel. It can be downloaded and
installed from Apple App Store® or Google Play Store® on your smartphone.

4. Sleep Mode

To conserve battery power, CODAWheel enters sleep mode after a period of
inactivity. Click CODAWheel to leave sleep mode. Red LED will start to blink and the
connection between your phone and CODAWheel will resume. Once CODAWheel
becomes active, it does not require any other setup.

5. Mounting

CODAWheel can easily be placed anywhere in your car. You can attach it on the
steering wheel, dashboard, or next to gear shift. Included in the box are double sided
tape and Velcro sticky fastener for mounting purposes.

One-Year Limited Warranty.

Enustech warrants the said product to be free from defects in materials and
workmanship for 1 year. If the said product is found to be defective, Enustech will
repair or replace it. If you have any questions, comments or concerns about the said
product, please contact :

Email:

Phone:

www.bcoda.com

Technical Support

www.bCoda.com/support

(C) 2014 Enustech Inc. All rights reserved.

bCoda

(tm)

and CODAWheel

(tm)

are registered trademarks of Enustech, Inc. Korea.

iPhone®, iOS®, Siri®App Store® are registered trademarks of Apple Inc.

Android® and Play Store® are registered trademarks of Google Inc.

Velcro® is a registered trade mark of Velcro Industries B.V.