Enttec 8PL60-F-12 Data Sheet
Datasheet
For latest version visit:
www.enttec.com
1
ID: 2082143
Pixel Tape 8PL60 12V
Features
• RGB, 3 in 1 full colour LED pixel tape.
• Available in 60 LED’s per meter
• 3 LEDs grouped per pixel
• 60 DMX channels per metre
• Designed for use with ENTTEC Pixel Link System
• Up-to 12.84 Watt/Metre
• Up-to 250 Lumens/Metre
• WS2812B chips built into 5050 RGB LEDs
• Each pixel can achieve 16,777,216 full colour dis-
play and scan frequency not less than 400Hz
• 3M adhesive double side tape at the back
• Built-in data signal reshaping circuit
• 12V DC input supply voltage
• Flexible construction material
• Can be joined together
• Can be cut into a smaller length
• IP20 Indoor use only
• Maximum run length 12m
Safety
• Do not expose the units to rain
• Do not allow water or other liquids to build up
around the tape.
• Do not exceed the rated 12V DC power supply.
• Please adhere to installation instruction sheet
• This unit is intended for indoor use only, use of
this product outdoors, voids all warranties.
Dimensions
• 50mm spacing between each cutting point.
Connections with Pixie Driver
It is important to turn off the mains to the devices before
doing any led tape connections.
Note:
• The wire in the middle of a JST connector is always
DATA regardless of color
• It is important to turn off the mains to the devices
before doing any led tape connections.
• Some tapes have extra supply wires, these must
also be connected (Red:12V & Black: GND)
Datasheet
For latest version visit:
www.enttec.com
2
ID: 2082143
Connections with Plink Injector:
Note:
• The wire in the middle of a JST connector is al-
ways DATA regardless of color
• It is important to turn off the mains to the de-
vices before doing any led tape connections.
Specifications
Note
All power measurements (watts/metre) were carried out
using 1m of tape supplied with a Voltage of 12V
Ordering Information
The ENTTEC 8PL Pixel strips and compatible products can
be ordered from our website or through your ENTTEC
dealer.
Item
Value
73542
PIXIE DRIVER 12V (65 WATTS)
73543
PIXIE DRIVER 12V (130 WATTS)
73544
Plink Injector 12-24V
8PL60-F-12
RGB PIXEL TAPE 60 LEDS/METER 12V
- 5M Roll
Item
8PL60-F-12
Input Voltage
+12V ~ +12.3VDC
Data line Voltage
-0.5V ~ +5.5V
Watts/meter (max)
Red
4.08 W
Green
4.92 W
Blue
4.92 W
All (RGB)
12.84 W
Lumens/metre
250
DMX Channels/Pixel
3
DMX Channels/metre
60
LEDs grouped/Pixel
3
Beam angle
120 °
Control protocol
WS2812B
Connector
JST SM connectors
Weight
150g
Operating
Temperature
5 to 50°
Pixel Mapping
Order
RGB (Red, Green, Blue)
Front polymer encapsulation seal
No
IP Rating
20
PCB Color
White
Loading...