Empire e100 Instruction Manual

e100 INSTRUCTION MANUAL
Features:
Easy to read back light
Display reads right side up even if the level is upside down
Automatic shut-off
Laser can be used when digital level is off
Zero button to easily calibrate measurements
Units button shows degrees, pitch/slope percentage and in/ft
Push-button memory to hold measured angle
Horizontal and vertical TrueBlue
®
Level Vials can be used for back-up and calibration
Heavy duty 6061 aluminum frame with milled edges offer strength and accuracy
Ergonomic rubber hand grips for comfort
Dual molded rubber end caps for shock resistance
For Your saFetY:
Important: Read and understand all instructions before using this tool. Failure to follow all
of the following instructions may result in fire, electrical shock or other serious injuries.
Read and carefully follow directions and warning on battery package.
Be sure to insert batteries correctly. Polarity (+ and −) is clearly marked on tool.
Do not short battery terminals or charge the batteries.
Do not mix old and new batteries. Always replace weak batteries with two (2) “AA” of the same
brand. Immediately remove dead batteries and dispose of them in accordance with your local ordinances.
Do not dispose of batteries in fire.
Keep batteries out of reach of children.
Remove batteries if tool will not be used for several days or longer.
1
The Empire Digital Level Accuracy, Readability, Durability one
2
The Empire Digital Level Accuracy, Readability, Durability two
• Laser light emitted from this aperture - Do not stare into light beam.
• Do not remove or deface any product labels.
• Always keep it out of the reach of children.
• Do not attempt to repair or disassemble the Digital laser level.
• Do not operate the tool in combustible areas.
• Do not attempt to modify the performance of the laser device in any way.
• Use of controls, adjustments or the performance of procedures other than
those specified in this manual may result in hazardous radiation exposure.
• The use of optical instruments such as, but not limited to, telescopes or
transits to view the laser beam will increase eye hazard.
proBleM solVing:
If display screen does not light when level is turned on, be sure that batteries are correctly
inserted and check battery charge as replacement may be needed.
If you experience other problems, contact the Empire Service Department at 1.800.558.0722.
care anD Maintenance:
Handle your Empire Digital Level with care at all times. Appropriate use and maintenance
will help to keep it accurate and in good working order.
Wipe clean with a damp cloth (water only) as needed. Do not immerse in water.
Do not store level at extreme temperatures above 140° or below 20°F (-6º C to 60º C).
Loading...
+ 5 hidden pages