ELRO C935IP User Manual

Wireless APP Camera

Installation and Operating Instructions

Version 1.0

PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE USING THIS PRODUCT

AND KEEP THIS MANUAL FOR FUTURE REFERENCE.

C935IP

The state of art WAPP camera is capable of deliver high quality Digital High Definition (HD) video to your smart-mobile device(s), which would require higher internet bandwidth. Due to your local internet environment condition, your mobile device(s) may display black-screen or temporary disconnect to the WAPP camera. Make sure the WAPP camera is operating with sufficient internet bandwidth, 1Mbps (upload/download speed) is suggested. For best performance, the smart-mobile device(s) need to be on Wi-Fi or 4G mobile network in order to receive maximum download speed. When the internet transmission is low, your WAPP APP will automatically switch to Relay Mode: By adjusting to “Better Streaming” in the system setting section may improve the WAPP APP performance. Your internet bandwidth is limited. For best performance, try to avoid more than two users connecting to the WAPP camera simultaneously. Make sure your smart-mobile device(s) is equipped with up-to-date technology, 1.5GHz dual core processor or equivalent is suggested. If the signal strength of your Wi-Fi router is weak, there are several ways to improve transmission: Change router/camera relative position to receive better signal. Use wire Ethernet cable on the WAPP camera to establish connection between WAPP camera and your router. Use Wi-Fi repeater/extender to maximize the service range of your Wi-Fi route. Switch your router to 11b/11g mode in order to improve router service range. Purchase extension cable or high gain antenna for your camera from the WAPP vendor. Please make sure the memory card used is CLASS10 rated.

CONTENTS

INTRODUCTION ............................................................................................................. 2

WIRELESS DEVICES OPERATING RANGE

IMPORTANT SAFETY PRECAUTIONS KIT CONTENT SAFETY AND INSTALLATION TIPS

NIGHT VISION ....................................................................................................... 6

CAMERA INSTALLATION CAMERA OVERVIEW

DOWNLOAD AND SETUP THE APP ............................................................................ 8

LIVE VIEW / SNAPSHOT / RECORDING

VIEWING YOUR SNAPSHOTS ........................................................................................ 12

PLAYBACK YOUR VIDEOS MAIN PAGE OVERVIEW

ADVANCED SETTING ....................................................................................................... 21

ADMIN PASSWORD .................................................................................................. 22

EMAIL ALERT

TIME ZONE.................................................................................................................23

DAYLIGHT SAVING

DEVICE SECURITY CODE

VIDEO SETTINGS

WI-FI SETTING

SENSITIVITY SETTING

EMAIL SETTING

SD CARD SETTING

OVERWRITE SD CARD

PROFILE SETTING

DEVICE INFORMATION ......................................................................................... 26

PRODUCTION SPECIFICATION .................................................................................... 30

STORAGE MEDIA MANAGEMENT ............................................................................... 31

.............................................................................................................................. 4

....................................................................................... 5

.................................................................................................... 6

................................................................................................................ 6

..................................................................................................... 12

......................................................................................................... 16

................................................................................................................................. 22

.............................................................................................................. 23

................................................................................................. 23

........................................................................................................... 23

................................................................................................................ 24

................................................................................................. 25

............................................................................................................. 25

......................................................................................................... 26

.................................................................................................. 26

......................................................................................................... 26

.................................................................. 2

....................................................................... 2

.............................................................. 11

INTRODUCTION

PLEASE READ BEFORE YOU START

Always use discretion when installing CCTV equipment, especially when there is perceived policy. Enquire relevant local regulations applicable to the lawful installation of video recording/surveillance. Third party consent may be required.

WIRELESS DEVICES OPERATING RANGE

Ensure the signal reception viewed from the wireless camera(s) is the best possible reception between the camera(s) and the Wi-Fi router. If necessary, reduce the distance between the camera(s) and the Wi-Fi router to improve overall system performance. Wireless Color Camera Recordable CCTV Kit operating on a secure digital 2.4GHz frequency which could greatly reduce interference from product such as wireless routers, cordless phones or microwave ovens.

IMPORTANT SAFETY PRECAUTIONS

Damages caused by non-compliance with this operating manual will void the warranty! We will not assume any liability for damages to items or persons caused by improper handling or non-compliance with the safety notices! Any warranty claim will be null and void in such cases.

1. Do not drop, puncture or disassemble the camera; otherwise the warranty will be voided.

2. Avoid all contact with water, and dry hands before using.

3. Never tug on the power cords. Use the plug to unplug it from the wall outlet.

4. Do not expose the camera to high temperature or leave it in direct sunlight. Doing so may damage the camera or cause camera temporary malfunction.

5. Use the devices with care. Avoid pressing hard on the camera body.

6. For your own safety, avoid using the camera or power off the camera when there is a storm or lightning.

7. Remove the power adapter during long periods between usages.

8. Use only the accessories and power adapters supplied by the manufacturer.

9. To meet the regulations pertaining to parental responsibility, keep the devices out of the reach of infants.

10. Check power cables, do not get crushed or damaged by sharp edges whenever the devices are in operation.

FCC Compliance Statement: This device complies with Part 15 of the FCC rules. Operation is subjected

to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

(2011/65/EU) issued by the Commission of the European Community. Compliance with these directives implies conformity to the following European Norms: EMC: EN 301 489

Products with CE Marking comply with EMC Directive (2004/108/EC); Low Voltage Directive (73/23/EEC); R&TTE(1999/5/EC); ROHS Directive

LVD: EN 60950 Radio: EN 300 328

FCC/CE WARNING This equipment has been tested and found to comply with limits for a Class B digital device, pursuant to Part 15 of the FCC rules and ETSI(EN) 300328. These limits are designed to provide reasonable protection against harmful interference in residential installations. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does interference to radio or television equipment reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna.-Move the equipment away from the receiver.-Plug the equipment into an outlet on a circuit different from that to which the receiver is connected.-Consult the dealer or an experienced radio/television technician for additional suggestions. You are cautioned that any change or modifications to the equipment not expressly approved by the party responsible for compliance could void your authority to operate such equipment.

DISPOSAL

If the camera system no longer functions or can no longer be repaired, it must be disposed of according to the valid statutory regulations. Disposal of spent batteries/accumulators:

You are required by law (Battery Ordinance) to return all spent batteries and accumulators. Disposing of spent batteries/accumulators with common household waste is prohibited! Batteries/accumulators that contain hazardous substances are marked with the symbols on the side. These symbols indicate that it is prohibited to dispose of these batteries/accumulators in the household waste. The abbreviations for the respective heavy metals are: Cd=cadmium, Hg=mercury, Pb=lead. You can return spent batteries and accumulators that can no longer be charged to the designated collection points in your community, outlets or wherever batteries or accumulators are sold. Following these instructions will allow you to fulfill the legal requirements and contribute to the protection of our environment!

KIT CONTENT

Wireless App Camera x 1

Camera Antenna x 1

Screw Pack x 1

Manual CD x 1

Camera Stand x 1

Power Adapter x 1

Rj45 Connect Jack x 1

Quick Start Guide x 1

Tools Required:

Electric drill 5mm masonry drill bit

15mm masonry drill bit No. 2 Philips screwdriver

For best system performance:

- iOS: iPhone4S / iPad2 / Mini iPad or above. Maximum 12 registered camera connections.

- Android: 1.5G dual core processor or above / 960*540 pixel or above. Maximum 12 registered camera connections.

- Storage: Class 10 memory card.

- Bandwidth: 1Mbps or above upload/download speed suggested.

SAFETY AND INSTALLATION TIPS

Do not attempt to open the units with the power adaptor plug connected to avoid any risk of personal injury.

When installing CCTV camera(s), always follow manufacturer's advice when using power tools, steps, ladders, etc. and wear suitable protective equipment (e.g. safety goggles) when drilling holes. Before drilling holes through walls, check for hidden electricity cables and water pipes. The use of cable/pipe detector is advisable.

It is also advisable to avoid exposing any cameras to extreme weather conditions (e.g., under a gutter which is prone to any water leaks). When installing any cameras with this unit, it is advisable to use cable conduit to protect any video/power extension cables from being exposed externally and to prevent/reduce the chances of the cables being tampered with. After drilling any hole though an external wall for a cable, ensure the hole is sealed up around the cable using a sealant to prevent drafts.

To prevent a fire or electrical shock hazard, do not attempt to open the housing while the unit is exposed to rain, water or wet conditions. There are no user serviceable parts inside. Refer servicing to qualified service personnel. Avoid pointing the camera(s) directly at the sun or any bushes, tree branches or moving objects that might unnecessarily cause the camera to record.

NIGHT VISION

The camera has built-in infrared LEDs to allow you to view at night for 24-hour surveillance. The LEDs will automatically activate at night and the picture viewed will turn to black and white. The night viewing range is up to 5 meters.

CAMERA INSTALLATION

Secure camera stand on the

Ceiling Mount Wall Mount

stable surface.

Loosen up the Thumb screw.

Adjust proper view angle then secure the joint with T-bolt.

CAMERA OVERVIEW

Power Indicator

PIR

Signal Indicator

Infrared LEDs

Stand

Power Cable

SD Card Slot

Antenna

RJ-45 Cable

DOWNLOAD AND SETUP THE APP

The Wireless APP camera is designed to deliver live video footage directly to your smart phone or tablet device. Please follow these steps to download, setup and use the APP.

APP Name: OMGuard HD

Download the App

1. From you smart phone or tablet device, click the APP Store/Google Play and search for “OMGuard HD”.

2. Once located the APP, select download.

3. Once download completed, you will find the APP icon on your mobile device screen.

APP Setup

△

BEFORE YOU START

Before connecting the camera to power source, first connect the camera to your Wi-Fi router by using only the Ethernet cable provided. After the camera is connected to the Wi-Fi router, connect the camera to power source and wait until both RED and GREEN LED begin flashing. DO NOT begin the setup process until both LEDs become steady on (roughly 45 seconds). Please follow the steps in the following pages to complete the setup.

+ 23 hidden pages