Elkay LKAV4061LS Installation manual

Important!

You choose the flow rate!

This faucet ships with an
eco-friendly 1.5GPM flow regulator
installed.

If you desire higher flow rate, a

2.2GPM flow regulator has also

been included in the box.
Switching the flow regulator is

simple! See the "Flow Regulator
Replacement" section for details.

INSTALLATION / OWNER'S MANUAL

Single Handle Kitchen Faucet

Model # LKAV4061

Groove joint pliers

Wrench

(2) 1/2 in Supply Lines

Screwdriver

SAVE FOR CONSUMER

OPTIONAL 2.2GPM FLOW
REGULATOR

Sealant Tape

Plumber's Putty

WARNING: Please carefully read and properly follow the instructions for installation found in this manual.

STEPS:

Ø 1 3/8" (Ø35mm)

1
2

3

Shut off water supply at angle stop. Clean sink surface
in preparation for new faucet.

1

2

3

4

5

Make connections to water lines with 3/8" female
compression supply hoses (1).
If additional hose length is needed, attach included 1/2"
MIP thread adaptors (2) to supply hoses (1). Use 1/2"
I.P.S. faucet connections (3) or use coupling nuts (5)
with 3/8" O.D.ball-nose riser (4) to make connections to
water lines. Use wrenches to tighten connections. Do
not overtighten.

Insert supply hose assembly through hole of sink. From
underneath sink, secure faucet with plastic washer (1),
metal washer (2) and nut (3). Firmly tighten retaining nut.
Do not overtighten.

Important: after installation is completed, turn
on hot and cold water supplies, check for leaks. Pull the
hose assembly out of the spout and remove the spray
head by unscrewing it from the hose counterclockwise.
Be sure to hold the end of the hose down into the sink
and turn the faucet on to the warm position where it
mixes hot and cold water. Flush water lines for one
minute. Check for leaks. Re-tighten any connections if
necessary, but do not overtighten. Reinstall spray head
by hand tightening it back onto the spray hose.