INSTALLATION / OWNER'S MANUAL
Single Handle Bar Faucet
Model # LKAV3021
Groove joint pliers Wrench
SAVE FOR CONSUMER
Screwdriver
Sealant Tape
Plumber's Putty
WARNING: Please carefully read and properly follow the instructions for installation found in this manual.
STEPS:
2
1
1
2
3
4
Optional Flange Installation:
Before installation, place the faucet
assembly through the mounting hole in
sink.
1
2
Make connections to water lines.
Thread the nut (1) on the supply line onto
the outlet of the water supply valve (2) and
tighten with a wrench.
Do not overtighten.
Optional Deck Plate Installation:
Before installation, align the hole in the
gasket (1) and deck plate (2) with the
mounting ho le in the sink. Place the
faucet assembly through the deck plate
(2) and mounting hole in the sink until
the faucet assembly sets on top of deck
plate (2).
NOTE: If the sink is uneven, use silicone
under the gasket (1).
Important: After installation is
completed, remove aerator. Turn on
hot and cold water supplies. Turn
handle to full open position for one
minute. Check for leaks. Replace
aerator.
Secure the faucet assembly with the
washers (1&2) and nut (3). Hand tighten
the nut (3) onto the faucet assembly. Lock
the nut (3) into po sition by tightening the
screws (4) with a phillips screwdriver.