Elkay LKAV1031CR, LKLFAV1031NK Installation manual
SAVE FOR CONSUMER
Includes:
INSTALLATION / OWNER’S MANUAL
Avado - Pull-Down Kitchen Faucet
LKAV1031CR
LKAV1031NK
LKLFAV1031CR
LKLFAV1031NK
NOTE: only 1 D1 washer is
1
D
used with this faucet model
C
Tools:
D
E
2
C
1
C
2
D
1
D
B
13/16”
[20 mm]
1/2”
[13 mm]
13/16”
[21 mm]
5/8”
[16 mm]
1
B
2
B
3
B
A
NOTE: these washers are not
used on this faucet model
WARNING: please carefully read and properly follow the instructions for installation found in this manual.
STEPS:
321
A
Before inse rting the single lever grou p in the hole of
the sink, make sur e that the base gasket is proper ly
positio ned in its seat and that the exible hoses are
well tighte ned to the body of the ta p.
Place th e single lever g roup in the hol e of the sink,
orienti ng the spout toward th e sink tank.
4
2
D
Attach the c ounterweight (D2) to the exib le hose
approxim ately 15- 3/4” [400 mm] from the connect ion
to the outle t pipe.
2
13/16”
[21 mm]
B
3
B
1
B
For counter top thicknesses less tha n 1/16” thi ck
use the ange (B1), for all oth er inst allations use
the metal wa sher (B2).
Secure mounting hardware in place by tight ening
mounting n ut (B3).
5
5/8”
[16 mm]
Connect the exible hoses to the supply connect ions
with rubb er gaskets.
Secure wi th wrench.
Turn on the water an d check for leaks.
Red
Hot
Blue
Cold
2
C
13/16”
[20 mm]
1
D
1/2”
[13 mm]
Install th e check valve (C1) to the outlet hose w ith a
rubber was her (C2).
Secure wi th wrench.
Attach t he pull-down ho se to the bottom of the
check valv e with a rubber washe r (D1).
Secure wi th wrench.
1
C
CARTRIDGE REPLACEMENT
321
1-1/8”
[28 mm]
C
B
1/8”
[2,5 mm]
Before dis sassembling the f aucet be sure that the w ater supply is turne d off.
Remove the n ish cap (A), paying atte ntion not to damage it . Remove the setscrew ( B) with a 1/8” [2,5mm] hex wre nch. Remove the handl e (C). Lift the nishing r ing nut (D)
using the refe rence notch. Unscrew th e cartridge nut (E) the n pull out th e cartridge (F). Put the ne w cartridge into the bo dy of the faucet, checkin g that the two centering pi ns
enter into th e respective seat s (X) and that the gasket s on the cartri dge are well positio ned.
Reassmbl e the handle followi ng the instructi ons in reverse order.
A
E
F
X
D
REPLACEMENT OF THE HAND SHOWER
321
A
1/16”
[2 mm]
Before ope rating, ensure the wate r supply is turned
off.
Unscrew the fas tening pin of the hand sho wer (A)
and remove it f rom its connecti on (B).
B
E
Remove the connection of the hand shower from the
hose (E).
3/4”
11/16”
[18 mm]
[19 mm]
C
Disasse mble the ho se-carrie r connectio n from the
hand shower c onnection (C).
54
F
Remove the hand shower, completely disconnected,
to carry out the replacement (F).
Finally reassemble the whole with the opposite procedure.
11/16”
[18 mm]
D
11/16”
[18 mm]
C
Unscrew th e connection (C) fro m the hose (D).
AERATOR CLEANING / REPLACING
1
E
Before rem oving the aerator ma ke sure that the faucet i s turned off.
Unscrew th e aerator using the ae rator installtio n key (E) included with t he faucet.
If the aerat or is clogged just r inse it with runnin g water. Do not use detergent s.
Reassemb le the aerator by follo wing the instruc tions in reverse ord er.
2
Loading...