Elkay HAC, HVR, HVRGRN, EMABF, VRC Installation Manual
...
Installation Instructions
Cane Touch Apron Replacement Kits
This kit is designed to be used with:
HAC, HVR, HVRGRN, EMABF, VRC & VRCGRN models
manufactured after July 2007.
Installation Procedure:
1. Using cane apron as a template use a center punch to mark hole
locations on front of left and right side panels.
2. Drill 1/8” diameter holes at marked locations. (Center punch hole
locations before drilling). When drilling the right hand hole on
refrigeration units, be certain to drill straight.
CAUTION: Keep the drill bit away from the refrigeration condenser.
If the drill damages or punctures the condenser refrigeration tubing
severe and expensive damage to the refrigeration system will result.
3. Loosen and remove (2) front screws from underside of cooler
dispenser panels.
4. Install cane touch apron to underside of cooler dispenser panels
and reuse fasteners removed in step 3 above.
5. Attach lower edges of apron to cooler side panels with screws
provided. (Using two holes drilled in step 2 above)
STYLE OF COOLER
MAY VARY
Required Tools:
To install this kit the following tools are required:
• Phillips Head Screwdriver
• Pinned Torx Head Driver
• Power Drill with 1/8” Drill Bit
• Hammer and Center Punch
CANE TOUCH APRON REPLACEMENT KITS
(COLOR OPTIONS)
*KIT PART NO. FINISH
98324C Stainless Steel (For all Models)
98312C Platinum Vinyl (HAC/HVR)
98313C Light Gray Vinyl (EMABF/VRC)
*Kits consist of cane apron, screws and pinned torx bits.
UNIT W/O REFRIG.
SHOWN
CANE TOUCH
APRON
SCREWS PROVIDED
www.elkay.com
www.halseytaylor.com
1/8" DIA. HOLE (2)
(SEE NOTE 2)
(SEE NOTE 5)
For purchasing Replacement Parts, please contact us at #800.834.4816
For Technical Questions, please contact us at #800.476.4106
98379C Rev B - (06/16)
Loading...