Elkay LKAPRVRCHD, HTAPRHVRHD Installation Manual

Cane Touch Apron - Installation Instructions

Model LKAPRVRCHD for use on VRCHD / LVRCHD style coolers

and Model HTAPRHVRHD for use on HVRHD style coolers

Required Tools:

To install this kit the following tools are required:

• Pinned Torx Head Driver (T25)

• Power Drill with 5/32” Drill Bit

• Hammer and Center Punch

Installation Procedure:

1. Using the cane apron as a template use a center punch to mark hole locations on the underside of the
HVRHD, VRCHD or LVRCHD coolers.

2. Drill 5/32” diameter holes at marked locations. (Center punch hole locations before drilling).
CAUTION: When drilling holes, keep the drill bit away from any water lines in cooler. If the drill
damages or punctures the tubing, expensive damage to the cooler could result.

3. Install cane touch apron to underside of cooler using the three (3) screws provided.

HD CANE

TOUCH APRON

HD UNIT W/O REFRIG. SHOWN

www.elkay.com
www.halseytaylor.com

SCREWS PROVIDED

For purchasing Replacement Parts, please contact us at #800.834.4816

For Technical Questions, please contact us at #800.476.4106

98730C Rev B - (06/16)