Space-ette® Series Flush to Wall Refrigerated
Models FD7003*, FD7005*, FD70010* & FD700D*
PRODUCT SPECIFICATION
Self-contained, electric oor model water cooler. Capacity of 50°F drinking
water, based upon 80°F inlet water and 90°F ambient. Model FD700D* is
non-refrigerated and shall deliver non-chilled drinking water. Cabinet design
allows for ush to wall installation. Removable front panel and cabinet sides.
Non-Pressurized tank system is standard.
Non-Pressurized tank system is standard. Non-pressurized water tank is located
after bubbler valve, so that tank is subject to line pressure only when valve
button is pressed.
Unit shall be lead-free design which is certied to NSF/ANSI 61 and 372 and
meets Federal and State low-lead requirements. Unit shall be certied to UL399
and CAN/CSA 22.2 No. 120.
STANDARD FEATURES
• Extra deep basin minimizes splashing; with integral vandal-resistant strainer
• Exclusive Flexi-Guard® Safety bubbler
• Cooler Panel Finish: Impact-resistant vinyl coating or Stainless Steel
• Rated for Indoor use
COOLING SYSTEM
• Compressor: Hermetically-sealed, reciprocating type, single phase.
Sealed-in lifetime lubrication.
• Condenser: Fan cooled, copper tube with aluminum ns. Fan motor is
permanently lubricated.
• Cooling Unit: Combination tube-tank type. Tube portion is continuous coil of
copper tubing. Fully insulated with EPS foam which meets Underwriters
Laboratories Inc. Requirements for self extinguishing material.
• Refrigerant Control: Refrigerant R134a is controlled by accurately calibrated
capillary tube.
• Temperature Control: Easily accessible enclosed adjustable thermostat is
factory preset. Requires no adjustment other than for altitude requirements.
Air Cooled Floor Mounted
RATED FOR INDOOR USE ONLY
CONSTRUCTION
• Stainless Steel basin with integral vandal-resistant strainer
• Galvanized structural steel cooler chassis provides structural
integrity
• Cooler cabinet available as Light Gray Granite or Sandalwood
Vinyl Clad Steel or Stainless Steel (additional cost) construction
• Exclusive Flexi-Guard® Safety bubbler utilizes an infused
anti-microbial pliable polyester elastomer to prevent accidental
mouth injuries. Flexes on impact
• † Option for additional Glass Filler (ordered separately)
Warranty: 5 year limited warranty on the unit’s refrigeration system.
Electrical components and water system are warranted for 12
months from date of installation or 18 months from factory shipment,
whichever date falls rst.
CAPACITIES CHART
Model Voltage / Hertz
† FD7003*1Z 115V / 60Hz 3.0 GPH 3.5 230 54 lbs. YES
† FD7003*2YJO 220V / 50Hz 2.5 GPH 2.0 230 54 lbs. YES
† FD7003*3YJO 220V / 60Hz 3.0 GPH 2.0 230 54 lbs. YES
† FD7005*1Z 115V / 60HZ 5.0 GPH 3.5 230 54 lbs. YES
† FD7005*2YJO 220V / 50Hz 4.2 GPH 2.0 230 54 lbs. YES
FD7005*3YJO 220V / 60Hz 5.5 GPH 2.0 230 54 lbs. YES
† FD70010*1Z 115V / 60Hz 9.8 GPH 6.8 535 65 lbs. YES
† FD70010*2YJO 220V / 50Hz 8.2 SPH 2.5 535 65 lbs. YES
FD70010*3YJO 220V / 60Hz 10.8 GPH 3.0 535 65 lbs. NO
FD700D* – – – – 29 lbs. NO
*Color code of (L) Light Gray Granite, (T) Sandalwood, or (S) Stainless Steel cooler panels.
**Based on 80°F inlet water & 90°F ambient air temp for 50°F chilled drinking water.
† Glass Filler available at extra cost. (Use Code (F). Requires factory preparation to
receive glass ller. (Glass Filler ordered separately.)
++Complies; not third party certied.
In keeping with our policy of continuing product improvement,
Elkay reserves the right to change specication without notice.
Please visit elkay.com for the most current version.
Chilling**
Capacity
F.L.
Amps
Rated
Watts
2222 Camden Court
Oak Brook, IL 60523
630-572-3192
elkay.com
† Glass Filler
(option) (F)
available
at extra cost
Approx.
Ship
Wt.
(order separately)
Requires
Factory prep to
receive glass lle
UL399 and
CAN/CSA 22.2
No. 120
Certied
NSF/ANSI
61 and 372
Certied
• •
++ •
++ •
• •
++ •
++ •
• •
++ •
++ •
• •
This specication describes an Elkay product with design, quality and functional
benets to the user. When making a comparison of other producer ’s offerings,
be certain these features are not overlooked.
SPEC09-05 (02/2016)
© 2016 Elkay
Open space rough-in design permits new installation or replacement of existing
fountains and coolers with this Elkay cooler when rough-in is within the outline shown.
IMPORTANT! INSTALLER PLEASE NOTE:
This water cooler has been designed and built to provide water to the user which has
not been altered by materials in the cooler waterways.
The grounding of electrical equipment such as telephone, computers, etc to water
lines is a common procedure. This grounding may be in the building or occur away
from the building. This grounding can cause electrical feedback into a water cooler
creating an electrolysis which creates a metallic taste or causes an increase in the
metal content of the water. This condition is avoidable by installing the cooler using
the proper materials as shown below.
Space-ette® Series Flush to Wall Refrigerated
Air Cooled Floor Mounted
Models FD7003, FD7005, FD70010 & FD700D
ROUGH-IN DIMENSIONS
RATED FOR INDOOR USE ONLY
This water cooler must be connected to the water supply using a dielectric coupling.
The cooler is furnished with a non-metallic strainer which meets this requirement.
The drain trap, which is provided by the installer, should also be plastic to completely
isolate the cooler from the building plumbing system.
1/4” O.D. TUBE
WATER INLET
TO COOLER
3/8” O.D. TUBE CONNECT
COLD WATER SUPPLY
NOTE: WATERFLOW
DIRECTION
BUILDING WATER
INLET
SERVICE STOP
(NOT FURNISHED)
A B C
FRONT VIEW SIDE VIEW
NOTICE
OPERATION OF QUICK CONNECT FITTINGS
OPERATION OF QUICK CONNECT FITTINGS
SIMPLY PUSH IN
SIMPLY PUSH IN
TUBE TO ATTACH
TUBE TO ATTACH
TUBE IS SECURED
TUBE IS SECURED
IN POSITION
IN POSITION
B CA
PUSH IN COLLET
PUSH IN COLLET
TO RELEASE TUBE
TO RELEASE TUBE
PUSHING TUBE IN BEFORE
PUSHING TUBE IN BEFORE
PULLING IT OUT HELPS TO
PULLING IT OUT HELPS TO
RELEASE TUBE
RELEASE TUBE
LEGEND
A = RECOMMENDED WATER SUPPLY LOCATION. SHUT OFF VALVE (NOT FURNISHED)
TO ACCEPT 3/8 O.D. UNPLATED COPPER TUBE.
B = RECOMMENDED LOCATION FOR WASTE OUTLET 1-1/4” O.D. DRAIN
C = 1-1/4 TRAP NOT FURNISHED
D = POWER CORD 4 FEET (1219mm) LONG
E = INSURE PROPER VENTILATION BY MAINTAINING 4” (102mm) (MIN.) CLEARANCE FROM
CABINET LOUVERS TO WALL.
F = TO LEVEL UNIT, LOOSEN SCREWS TO ADJUST BASE FOR CONTACT WITH FLOOR.
TIGHTEN SCREWS AFTER UNIT HAS BEEN LEVELED.
FINISHED
FLOOR
2222 Camden Court
Oak Brook, IL 60523
630-572-3192
elkay.com
Job Name: ____________________________________
Model: _______________________ Qty. ____________
Contact: ______________________________________
Approval Signature: _____________________________
Notes:
Printed in U.S.A.
© 2015 Elkay