Elkay ERPA8C Installation Manual
ERPA8C ERPAVR8C LPFEA8C
Installation/Care/Use Manual
SwirlFlo® Refrigerated Fountains with FLEXI-GUARD
®
41
SEE FIG. 11
36, 38, 39
SEE FIG. 4 OR 5
40
37
35
37
Installer
To assure you install this model easily and correctly, PLEASE READ
THESE SIMPLE INSTRUCTIONS BEFORE STARTING THE INSTALLATION. CHECK YOUR INSTALLATION FOR COMPLIANCE WITH
PLUMBING, ELECTRICAL AND OTHER APPLICABLE CODES. After
installation, leave these instructions inside the fountain for future reference.
IMPORTANT
ALL SERVICE TO BE PERFORMED BY AN AUTHORIZED SERVICE PERSON
IMPORTANT! INSTALLER PLEASE NOTE.
THE GROUNDING OF ELECTRICAL EQUIPMENT SUCH AS TELEPHONE, COMPUTERS, ETC. TO WATER LINES
IS A COMMON PROCEDURE. THIS GROUNDING MAY BE IN THE BUILDING OR MAY OCCUR AWAY FROM THE
BUILDING. THIS GROUNDING CAN CAUSE ELECTRICAL FEEDBACK INTO A FOUNTAIN, CREATING AN ELECTROLYSIS WHICH CAUSES A METALLIC TASTE OR AN INCREASE IN THE METAL CONTENT OF THE WATER.
THIS CONDITION IS AVOIDABLE BY USING THE PROPER MATERIALS AS INDICATED. ANY DRAIN FITTINGS
PROVIDED BY THE INSTALLER SHOULD BE MADE OF PLASTIC TO ELECTRICALLY ISOLATE THE FOUNTAIN
FROM THE BUILDING PLUMBING SYSTEM.
1/4" O.D. TUBE
WATER INLET
TO COOLER
FIG. 1
FIG. 3
NOTE: WATER FLOW
DIRECTION
45
3/8" O.D. UNPLATED
COPPER TUBE CONNECT
COLD WATER SUPPLY
42
BASIN
43
44
BUILDING WATER
INLET
SERVICE STOP
(NOT FURNISHED)
1
2
FIG. 4
FIG. 2
NOTE: WHEN INSTALLING
REPLACEMENT BUBBLER
3
AND PEDESTAL, TIGHTEN
NUT (ITEM 5 OR 51) ONLY
TO HOLD PARTS SNUG
4
IN POSITION. DO
NOT OVER
TIGHTEN.
5
49
50
51
FIG. 5
97674C (REV. B - 5/01)
ERPA8C ERPAVR8C LPFEA8C
MODEL LPFEA8C
LEGEND
A = 3/8" O.D. TUBE CONNECT (CHILLER WATER OUTLET)
B = 3/8" O.D. TUBE CONNECT (CHILLER WATER INLET) SHUT OFF VALVE BY OTHERS
C = 1-1/4" TRAP NOT FURNISHED
D = ELECTRICAL INLET
97674C (REV. B - 5/01)
FIG. 6
PAGE 2
Loading...